Wolf Garten HSB 36 Manual Del Usuario página 22

English
Switching hedge trimmer on/off
Ensure that you have a firm footing,
especially when working above head height.
Keep the cutter away from your body.
Switching on
 Hold down the safety switch on the hand

grip .
 Simultaneously press the On/Off switch

on the handle
Switching off
 Release one of the two switches.
The cutter stops immediately.

Cutting
To ensure that you have an ergonomically optimum
hand posture in all cutting situations, the hedge
trimmer features a user-friendly Ergo handle
Information about cutting
 The hedge trimmer can be operated in 3 working
positions: cutting sideways, cutting high up and
cutting low down.
– When cutting sideways, hold the guide handle

sideways as shown in Fig.
– When cutting high up, hold the guide handle

above as shown in Fig.
– When cutting low down, hold the guide handle

above as shown in Fig.
 Never place your hands and fingers between
the blades of the hedge trimmer or in the areas
in which your hands and fingers could become
jammed or be cut.
 Never touch the cutter while operating the hedge
trimmer or with the battery inserted.
 Do not use the hedge trimmer in the rain
or for cutting wet hedges.
 Before using the hedge trimmer, check it for
damage. Do not operate the machine unless
it is in a technically sound condition and have
damage repaired by a qualified technician
or the service centre.
 When working with or on the hedge trimmer,
always wear the appropriate personal protective
equipment (safety boots, goggles, hearing
protection, non-slip protective gloves, etc.).
 Please ensure you have a firm footing when
cutting above head height to prevent you from
slipping and sustaining further injuries.
 Please note the breeding seasons of birds!
 Always cut with both hands.
 Keep the cutter away from your body.
18

.

.

.

.
 Use the hedge trimmer only at reasonable times
of the day and not early in the morning or at night
when you may disturb people.
 The ideal shape to cut a hedge is trapezoidal
as this shape ensures that all areas of the hedge
have adequate light and air.
 Shorten new shoots only to half the length in
order to promote dense growth in young hedges.
 If the hedge has already reached the required
height, you can completely remove new shoots.
 If branches are too thick for the cutter, cut them
off with a saw.
Attention! Dual action blades!
Switch off the hedge trimmer if the cutter
is blocked, e.g. by thick branches, etc.
– Remove the battery.
– Do not grip running cutting edges.
– Eliminate the cause of the blockage.
Cutting the top of the hedge

.
 When cutting the top of the hedge, guide
the hedge trimmer to the left and right
in swinging/sweeping movements.
 To obtain optimum cutting results, point the cutter
downwards slightly in the direction of the cutting
movement.
 To ensure that the height of the hedge is even,
you can peg out a string line at the required height
and cut along this line.
Cutting the sides of the hedge
 If cutting the sides of the hedges, start cutting
the lower part of the hedge and work upwards.
 To obtain optimum cutting results, point the cutter
downwards slightly in the direction of the cutting
movement.
 Cut the sides of the hedge tapering upwards
to ensure an even hedge growth.
Cutting times
 Deciduous hedges: May/June and October
(in winter cut back by approx. 1/3 of the total
height)
 Coniferous hedges: April and October
 Conifers: April and October
Operating manual hedge trimmer
Operation
