Additional Safety Instructions - YATO YT-82288 Manual De Instrucciones

GB
elements of the tool may lead to serious injuries. Keep your balance. Maintain an appropriate position. It will permit to control
the electric tool in case of unpredicted situations during its operation. Use protective clothes. Do not wear loose clothes or
jewellery. Keep your hair, clothes and gloves away from moving elements of the electric tool. Loose clothes, jewellery or
long hair may get caught on moving elements of the tool. Use dust extractors or dust containers, if the tool is equipped with
any. Make sure they are properly connected. Using of dust extractors permits to reduce the risk of serious injuries.
Operation of the electric tool
Do not overload the electric tool. Use a proper tool for the given purpose. A correct selection of the tool for the given work
will result in a more efficient and safer work. Do not use the electric tool if the switch is not functioning properly. A tool which
may not be controlled by means of a switch is dangerous and must be repaired. Disconnect the plug from the mains socket before any adjustment, replacement of accessories or storage of the tool. It will permit to avoid accidental activation of the
electric tool. Store the tool away from children. Do not allow untrained persons to operate the tool. An electric tool may be
dangerous in hands of an untrained person. Make sure the tool is properly maintained. Check the tool in order to detects
any unfitting or loose moving elements. Check whether the elements of the tool are not damaged. In case any damaged
elements of the tool are detected, they must be repaired before the electric tool is operated. Many accidents are caused
by improper maintenance of tools. Cutting tools must be sharp and clean. Properly maintained cutting tools are easier to
control during work. Use electric tools and accessories in accordance with the aforementioned instructions. Use the tool
in accordance with its purpose, taking into account the kind and conditions of work. Should the tool be used for other ap-
plications than the ones it has been designed for, the risk of a dangerous situation increases.
Repairs
The tool may be repaired only by authorised service centres, which must use solely original spare parts. It will guarantee
a proper level of safety of operation of the electric tool.

ADDITIONAL SAFETY INSTRUCTIONS

Before operating the tool, make sure the casing and the cable with the plug are not damaged. In the case of any damage further
operation of the tool is prohibited.
Careless operation of the tool may cause a fire.
Be careful operating the tool where there are inflammable materials.
Do not direct the hot blast towards the same place for a long period of time.
Do not use the tool in explosive atmosphere.
Never use the tool in humid air.
Never obstruct the air intakes of the tool.
Heat may be transferred to inflammable materials that are placed out of the visual field.
Do not leave a functioning tool unattended. Never direct the hot blast towards people or animals.
Never use the tool as a hairdryer.
Do not use the tool in the bathroom or close to water.
Do not touch the nozzle of the tool, it may cause burns.
After use, wait until the tool cools down before it is stored.
ASSEMBLY OF ADDITIONAL ELEMENTS
ATTENTION! Additional elements may be assembled solely when the tool is not connected to the mains. Unplug the tool!
If the tool is equipped with accessories, they may be assembled according to the following instructions:
Assembly of the paint scraper with a triangular terminal (II)
Remove the nut from the thread and put the threaded part of the scraper rod through the triangular plate. Then fasten the nuts
– the holding and the control ones.
Assembly of nozzles and handles (III)
An appropriate nozzle is to be placed on the outlet of the tool.
PREPARATION AND OPERATION OF THE TOOL
Before operating the tool, make sure the casing and the cable with the plug are not damaged. In the case of any damage further
operation of the tool is prohibited.
O P E R A T I N G M A N U A L
11