Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation (continued)
7
Balancing the blades
All blades are grouped by weight. Because natural woods vary in
density, the fan may wobble even though the blades are weight
matched.
The following procedure should correct most fan wobble. Check for
wobble after each step.
Check that all blade and blade holder screws are secure.
Most fan wobble problems are caused when blade levels
are unequal. Check this level by selecting a point on the
ceiling above the tip of one of the blades. Measure this
distance as shown in Figure 14. Rotate the fan until the
next blade is positioned for measurement. Repeat for each
blade. Measurements should be within 1/8 in.
If blade wobble is still noticeable, interchanging two
adjacent (side by side) blades can redistribute the weight
and possibly result in smoother operation.
Figure 14
8
Touch Ceiling
9
Installing the light kit
WARNING: To reduce the risk of electric shock ,
disconnect the electrical supply circuit to the fan before
installing light kit.
CAUTION: Glass is fragile and delicate, handle with care.
Overtightening of glass shade may crack it.
Install a light bulb (max. 9W, LED, medium screw base) to
the lampholder (Figur
e 15).
Install the lamp shade (F) into the lamp-fitter by a gentle
clockwise twist-and-lock (Figure 16).
Lamp Holder
Figure 15
Figure 16
Light Bulb
F
Tabla de contenido
