Finishing The Installation; Attaching The Fan Blades - HOMEDEPOT DB30TBN-LP Guía De Uso Y Cuidado

Ventilador de techo triplicity de 30 plug.
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installation (continued)
5

Finishing the installation

When the electrical connections have been
made, take the fan off the hook. Slide the ceiling
canopy up the downrod, making sure that the
ball joint groove engages with the ceiling canopy
entry hole tab. Slide the bayonet slots on the
ceiling canopy onto the screws at either end of
the mounting plate, secure with the four screws
provided (Figure 11).
Mounting
Plate
Ceiling
Canopy
Downrod
Figure 11
DB30TBN/ORB/WH-LP
6
Bayonet
Locating Slot
Screw
Hole
The fan blade assemblies are to be attached to the motor using the blade
Tab
holder screws (1) that are pre-installed into the fan motor. The procedure
to attach blade assemblies is as follows:
Groove
8

Attaching the fan blades

NOTE:
Your fan blades are reversible. Select the blade side
finish which best accentuates your decor. Failure to follow
below procedure could result in fan wobble.
Mount the blade holders (D) to the fan blades (E) using the
blade screws (AA), hex nuts (CC) and flat washers (DD)
provided - 3 each per blade (Figure 12).
CC
DD
D
AA
Figure 12
Remove the pre-installed blade arm screws and washers (2 each per
blade assembly) through the window at the bottom of the light kit.
Align the 2 holes in the blade arm to the 2 holes in the motor through
the window at the bottom of the light kit and tighten back the screws
and washers.
Repeat these steps to install the remaining blade assemblies.
1
Figure 13
E
Tabla de contenido
loading

Este manual también es adecuado para:

Db30torb-lpDb30twh-lp

Tabla de contenido