Uline H-2804 Guia De Inicio Rapido página 4

7. Set unit upright and tighten
all nuts and bolts around
the entire unit.
8. Insert shelves (5)
at desired levels.
(See Figure 7)
NOTE: To place the
shelves, tilt shelves slightly
to the left or right before inserting
into unit.
9. Attach the left door (8) to unit by placing the door on
the hinges, aligning the hinge holes, dropping the
hinge pins (15) into the slots, then placing the flat end
of a screwdriver on the hinge pins and tapping them
in with a hammer.
(See Figure 8)
8
Figure 8
10. Attach the right door (9) to the unit in the same way
the left door was attached. (See Figure 9)
NOTE: If having issues with doors aligning, it may
be due to cabinet not sitting level. Use included
nut driver to adjust leveling feet in bottom front
two corners. Nut driver should insert through
inside of cabinet down
into feet and adjust
as needed.
PAGE 4 OF 12
ASSEMBLY CONTINUED
5
Figure 9
9
HANDLE/LOCKING SYSTEM INSTALLATION
Figure 7
1. Place the locking handle (11) on the right
hand door and fasten with two
#8-32 x 1/4 slotted hex-head
bolts and lockwashers.
(See Figure 10)
2. Turn the handle to the open
position, and place the locking
cam (12) over the square shank
of the door handle. The cam
must be facing down
as shown. (See Figure 11)
Then place the locking
cotter pin (13) through
the hole of the square
shank. (See Figure 12)
3. With the handle still in
the open position, hook
the lock bars (10) to the
15
locking cam. Once in position,
slowly rotate the door handle
to the closed position so the
lock bars protrude from the
holes at the top and bottom
of the door. (See Figure 13)
4. Slide the nylon lock bar guides
(14) over the lock bar ends
and through the door slots.
Push firmly until the guides
snap into place. If necessary,
10
turn the handle back to the
open position and gently
tap with a hammer until
the guides slide into place.
(See Figure 14)
12
1-800-295-5510
uline.com
13
Figure 13
Figure 14
11
Figure 10
12
Figure 11
Figure 12
14
14
1120 IH-2804