Uline H-2804 Guia De Inicio Rapido página 3

ASSEMBLING CABINET
1. Place the back (1) on a protected surface.
The bottom flange should
be facing upward.
(See Figure 1)
Flange faces upward
NOTE: When bolting the unit together, leave
the bolts lightly loose until step 7, unless
otherwise instructed.
2. Attach the left
side (2) to the
back by placing
flange around
the back, and
bolting the
back and side
together with four
bolts and nuts.
Be sure that the
lances on all
shelf adjustment
strips point in the same direction. (See Figure 2)
3. Attach the top
(7) to the unit
by sliding the
outer flange
over the back
of the unit
and the side
flange to the
side panel
on the unit.
The threaded
studs should
go through the
holes in the
top flange of
the side and fasten with three nuts. Attach the back
to the top using four bolts and nuts. (See Figure 3)
4. Attach the right side (3) to the back in the same
manner as done in step 2, again making sure that
the flange is around the back and that the lances
on the shelf adjustment strips are pointed in the
same direction as those on the back and left side.
PAGE 3 OF 12
ASSEMBLY
1
Figure 1
2
Flange goes
under back
All lances point
UP on both
back and side.
Figure 2
7
Figure 3
Push the right side panel up so the studs in the top
go through the holes in the
top flange of side
and fasten with
three nuts.
(See Figure 4)
5. Attach the sill (4) to the sides. Place nut loosely on
each of the studs and slide the ends of the sill into
the slots on both sides on the unit. Then securely
tighten the nuts. (See Figure 5)
4
Slide ends into the slots
on the bottom of sides.
6. Place rear flange of the bottom (6) into the bottom
lances of the back. The flange with the two holes
should face the front,
hanging over the sill.
Insert bolts through
the bottom and sill
with the head
facing the front
of the unit. Secure
with two nuts.
(See Figure 6)
Figure 4
Nuts placed loosely
on studs of the sill.
6
1120 IH-2804
3
Figure 5
Figure 6