Description; Introduction; Packing List; Optional Accessories - AKG SPC4 Modo De Empleo

2.1 Introduction

2.2 Packing List

2.3 Optional Accessories

2.4 SPC 4

2.4.1 Front Panel

Fig. 1: SPC 4 front panel.
Refer to fig. 1.

2.4.2 Rear Panel

Fig. 2: Inputs and outputs
on the SPC 4 rear panel.
Refer to fig. 2.
12

2 Description

Thank you for purchasing an AKG product. This Manual contains important instruc-
tions for setting up and operating your equipment. Please take a few minutes to read
the instructions below carefully before operating the equipment. Please keep the
Manual for future reference. Have fun and impress your audience!
1 SPC 4 antenna combiner
1 19" rack mounting kit
• Check that the packaging contains all of the items listed above. Should any of
these items be missing, please contact your AKG dealer.
• For optional accessories, refer to the current AKG catalog or folder, or visit
www.akg.com. Your dealer will be glad to help.
The SPC 4 is an antenna combiner designed for the IVM 4 in-ear monitor system.
The antenna combiner allows you to combine the output signals of up to four SST 4
stereo transmitters into a single antenna signal. The SPC 4 will only operate with the
SRA 2 W passive directional antenna or RA 4000 W passive omnidirectional antenna
from AKG.
The SPC 4 can be powered either from an AC adapter with an output voltage of
12 VDC/≥1.4 A (not included) or the optional PSU 4000 central power supply.
1 2
1 ON/OFF: Pushbutton for switching power to the unit on and off.
2 Status LED: This tricolor LED indicates the following operating conditions:
Green: Power to the unit is on, the operating temperature is within the safe range.
Orange: Critical operating temperature, the unit may overheat.
Red: The unit has overheated or is connected to an antenna not approved by
AKG. Switch power to the unit off to avoid damage to the unit.
3 Ventilation grill: The unit incorporates a ventilator for cooling the electronic cir-
cuitry.
4 5
4 ANTENNA OUT: BNC output connector for an SRA 2 W or RA 4000 W transmit-
ting antenna. You may also connect this output to a transmitter input on another
SPC 4.
5 INPUT 1-4: BNC inputs for connecting one to four SST 4 stereo transmitters.
6 DC ONLY 12 V/1.4 A SPC 4: DC input for an AC adapter with a 12 VDC/≥1.4 A
output (not included) for powering the SPC 4.
7 DC ONLY 12 V/2 A SST: DC input for connecting the optional PSU 4000 central
power supply for powering the SST 4 transmitters connected to the SPC 4.
3
5 5 5 7 6
AKG SPC 4