Troubleshooting - Olympia TB 1280 Manual De Instrucciones

8

Troubleshooting

Problem
POWER indicator
does not light up.
The device has
switched off
automatically
Binding is faulty /
Loose sheets
If the problem cannot be solved, contact our Hotline; refer to Chapter
"Guarantee".
Diagnosis & Cause
The power plug is not
plugged into the power
socket properly.
The device was not switched
on.
The POWER ON/OFF LED
is defective.
The device switches off
automatically after 90
minutes without use.
The maximum binding
capacity was exceeded: Too
many sheets or the thermal
binding cover was too large.
The cooling down time was
too short.
20
Solution
Connect the power plug in
the power socket properly.
Press the POWER button
until the POWER LED lights
up red.
Contact our hotline (refer to
Chapter "Guarantee").
Switch the device on again
(refer to Chapter "Switching
the device on and off").
Observe the maximum
binding capacity, refer to
Chapter "Technical Data"
and carry out the binding
again.
Allow the bound document
to cool down in the tray for
at least 10 minutes.