KLeefer GLOBBER ONE K 165 Manual Del Usuario página 7

tubes of the T-bar. Wiggle and turn a bit until their spring loaded locking buttons
align with the holes and fix the whole steering bar assembly in place. Close clamp
lever.
2 - Folding the scooter
• Both hands on the handlebars, giving a slight kick pedal lock as shown in the
drawing 4. Fold back the T-bar handle until it locks on the back brake with an
audible click. as shown in the drawing 5.
• You can grip the scooter by the T-bar handle and pull it behind you for easy
transport.
• For purposes of storage, remove both parts of the T-bar handle from the T-bar.
• Open the clamp lever on the T-bar, press down the spring-loaded locking buttons
while pulling out the part sideways at the same time. Strings inside the tubes will
hold the individual part together. Clip the two parts of the T-bar handle into the
clips to both sides of the steering bar.
DO NOT FORGET TO REGULARLY TIGHTEN THE DIRECTION BLOCKS TO
AVOID MISALIGNMENT OR LOSS OF THE SCREW.
Care / Maintenance: regular maintenance is a safety commitment;
- Wheel bearings: avoid going through water, oil or sand as this can damage
wheel bearings. To look after the wheel bearings, systematically check that the
wheels turn properly by turning the scooter upside-down and using your hand
to spin the wheels. If the wheels do not spin they must be removed to check
their condition. First unscrew the wheel axle, remove the axle and detach the
wheel, then carefully push the two wheel bearings out of their housing. If they are
chipped or dented, new ones should be bought. If there is no visible damage,
they must then be oiled. To do this, remove all traces of grease, mud or dust with
a kitchen towel or cloth, and re-oil them with a grease spray or by leaving them to
soak overnight in oil [turn them several times in the oil first]. Then reassemble the
wheel bearings and axles, followed by the wheel, onto the scooter. Proceed in the
same manner for the other wheel.
- Wheels: the wheels wear down with time if overly used on rough surfaces. In the
interest of safety, they should be checked regularly and replaced if necessary.
- Modifications: the original product must by no means be modified except for the
maintenance-related changes mentioned in these instructions.
- Nuts, axles and other self-locking fixings: these should also be checked
regularly. They can become loose after a while in which case they should be
tightened. They can become worn and not tighten properly, in which case they
should be replaced.
Additional Info
For questions and inquiries please contact us at: [email protected]
WARRANTY
The manufacturer warranties this product to be free of manufacturing defects for
period of 2 years from date of purchase. This limited Warranty does not cover
normal wear and tear, tire, tube or cables, or any damage, failure or loss caused by
improper assembly, maintenance, or storage.
This Limited Warranty will be void if the product is ever
• used in a manner other than for recreation or transportation;
• modified in any way;
• rented
The manufacturer is not liable for incidental or consequential loss or damage due
directly or indirectly to the use of this product.
Globber does not offer an extended warranty. If you have purchased an extended
warranty, it must be honoured by the store at which it was purchased.
For your records, save your original sales receipt with this manual and write the
product name below.
...................................................................................
Spare parts
To order spare parts for this product, please visit our website:
www.globber.com
7