Troubleshooting; Technical Data - Flymo C-Li 20VHT Manual De Usuario

a WARNING: Always stop the power tool and disconnect the power cord before performing any of the
recommended remedies below.
Trouble
The motor fails to start when the
trigger is squeezed.
The power tool will not start.
Cutting blade stops under load
Fails to stop when one switch lever
is released.
Poor cut quality
Motor specifi cations
Motor type
Motor voltage
Motor power
Noise and vibration data
Equivalent vibration level (ahv, eq) front handle. See Note 1.
Equivalent vibration level (ahv, eq) rear handle. See Note 1.
Sound power level, guaranteed (LWA). See Note 2.
Sound power level, measured. See Note 2.
Sound pressure level at operator's ear. See Note 3.
Blade specifi cations
Blade speed
Blade length
Cutting capacity
Product mass
Weight (without battery pack)
Weight (with battery pack)
Note 1: Reported data for equivalent vibration level has a typical statistical dispersion (standard deviation) of 1.5 m/s
Note 2: Noise emissions in the environment measured as sound power (LWA) in conformity with EC directive 2000/14/
EC. Reported sound power level for the machine has been measured with the original cutting attachment that gives
the highest level. The difference between guaranteed and measured sound power is that the guaranteed sound power
also includes dispersion in the measurement result and the variations between different machines of the same model
according to Directive 2000/14/EC.
Note 3: Reported data for equivalent sound pressure level for the machine has a typical statistical dispersion (standard
deviation) of 3 dB(A).

TROUBLESHOOTING

Cause
1. Battery pack is not secure.
2. Battery pack is not charged.
1. Attachment not correctly
assembled in the powerhead.
2. Battery pack is not secure.
3. Battery pack is not charged.
4. Defective power switch.
Cutting too fast
Internal wiring defective
1. Debris caught in blades
2. Damaged blades

TECHNICAL DATA

Remedy
1. Make sure the battery pack is fully
secured in the power tool.
2. Charge the battery pack.
1. Assemble the attachment correctly in
the powerhead.
2. Make sure the battery pack is fully
secured in the power tool.
3. Charge the battery pack.
4. Call an authorized service center
Cut at a slower pace.
Call an authorized service center
1. Clear debris from blades
2. Call an authorized service center
unit
V (DC)
W
m/s
2
m/s
2
dB(A)
dB(A)
dB(A)
min
1
cm (in)
mm (in)
kg (lb)
kg (lb)
C-Li 20VHT
Brushed
20
270
1.8
1.1
98
95.3
85.8
1200-1350
40.6 (16)
12.7 (0.5)
2.53 (5.58)
2.92 (6.43)
.
2
9