Idiomas disponibles
Idiomas disponibles
7a. Mark dimension from outer edge of seat belt tower base and
install bracket as shown by snapping bracket to seat belt
tower base.
7b. Repeat steps for opposite side.
8a. If vehicle is not equipped with power convertible option, re-
install foam, carpet and then trim. If vehicle is equipped with
power convertible option, go to step 9.
8b. Repeat steps for opposite side.
9a. Using 10mm Socket, install new screw included with kit into
bracket and trim.
9b. Repeat steps for opposite side.
9c. Go to Step 13.
Corvette Windbreak
ALL INFORMATION WITHIN ABOVE
DATE
BORDER TO BE PRINTED EX-
ACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GMSPO SPECIFICATIONS.
REVISION
AUTH
10. If vehicle is equipped with power convertible top option, route
harness on bracket under carpet and foam, up to tonneau
panel lower hinge area. Remove push pin and cargo hook to
lift carpet. Disconnect the vehicle's power trunk panel
harness connector as shown.
11. Connect the vehicle's trunk panel harness connector to the
bracket harness connector as shown.
REV 22AU08
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Corvette Windbreak
PART NO.
88966629
6200 Grand Pointe Dr., Grand Blanc, MI 48439
3
88966629
SHEET
3
SHEET
15
OF
15
OF
