Idiomas disponibles
Idiomas disponibles
Veritek
TM
Natural Gloss
Composite
Model No.
BA-3060
Step-By-Step
Installation
Instructions
STOP
While the Bath Alcove is
specifically designed to fit the
TM
Veritek
Bathtub, it can be
installed over other manufac-
turers bathtubs. When setting
the back wall into place (see
step #4), it will be necessary
to file down the "wall tabs."
This procedure is to be done
ONLY if you are fitting the
Wall Alcove to a bathtub other
than the Veritek
TM.
.
Important:
This installation manual
includes the step-by-step pro-
cedure for both the BA-3060
wall system and the BT-3060
bathtub. Use this installation
sheet for complete assembly
of both units. You may disre-
gard owners manual provided
with BT-3060.
Included In
Carton
A. One Right Side Panel
B. One Left Side Panel
C. One Back Panel with
Six Factory Installed
Wall Mounting Clips
*NOTE: There are six factory
installed wall-mounting clips
strategically located along the
side flanges of the back pan-
el. These wall-mounting clips
are necessary for initial fit of
the side panel to the back
panel.
Bath Alcove Walls
B
(Bathtub is sold separately and is not included in Bath Alcove Walls Kit)
Preparation
Before you begin, remove the
bathtub from the protective
carton and inspect for dam-
age. Also, check to insure all
installation materials are
included in package.
Important:
Proper installation requires
that the bathtub be nested
into a bed of mortar-type
material (Quikrete). Improper
installation will void the
warranty.
C
Stud Pocket
Construction
For new construction installa-
tion, build a stud pocket to
the dimensions of Figure #2.
Using either wood or structur-
al steel studding, be sure that
all framing is plumb and
square.
For Remodeling
Upon removal of old bathtub,
measure alcove pocket to be
sure that the new bathtub will
fit in the available space. See
figure #2 for dimensions. It
may be necessary to recon-
struct one wall of the alcove
pocket per figure #2 floor
plan.
A
*
Figure 1
Drywall
If unit is to be installed over
drywall, allow for thickness of
drywall when building stud
pocket.
Plumbing
All supply lines to valves, tub
spout, and shower riser must
be located prior to bathtub
installation. Install these
items, as well as waste and
overflow in accordance with
the manufacturer's installation
instructions. This bathtub
accepts a standard 16"
adjustable drain and overflow
fitting. See figure #3 for
dimensions.
For remodeling, removal of
a portion of the subfloor may
be necessary. Replace subfloor
prior to bathtub installation.
