Allen + Roth 14307 Manual Del Usuario página 4

FAUCET ASSEMBLY INSTRUCTIONS
2. Ensure the gasket (B) is on the bottom of the
new faucet (A). Place the faucet (A) through
the mounting holes in the sink. Secure the
faucet assembly (A) to the sink with the
washers (C) and install nuts (D) provided.
Screw the washers (C) and install nuts (D) to
sink and hand-turn to tighten, as shown in
the Fig 1.
NOTE: If the sink is uneven, use silicone
sealant (not included) under the gasket (B).
3. Make connections to water lines. Use 1/2" I.P.S.
Faucet connections (1) or use supply line
coupling nuts (2) with 3/8" O.D. ball-nose riser
(3) (not included). Use wrenches to tighten
connections (not included). Do not overtighten.
NOTE: For this step plumber's tape (G) may be
needed to seal and lubricate the threaded pipe
joints. If needed, take a small strip of plumber's
tape and wrap it clockwise around the threads
of the water line before tightening the
connections.
2
2
B
3
C
D
4
3
4
A
C
3
D
Fig 1
5-1
1
2
3
B
G