Gira 5420 00 Manual De Instrucciones página 10

eNet
Actuador regulador radioeléctrico de 1 elemento mini
Behaviour on voltage return
Brightness on voltage return
Switch­off warning
Priority, lock­out protection
Priority, restraint
Priority, wind alarm
Priority, sun protection
32580702 10499446
On
Off
Last value
Configured brightness
Basic setting: Off
0...100 %
Basic setting: 100 %
On, Off
Basic setting: Off
0...4
Basic setting: 1
0...4
Basic setting: 2
0...4
Basic setting: 3
0...4
Basic setting: 0
12.03.2014
Defines the behaviour of the
output after voltage return.
Brightness value, set by the
output after voltage return
(mains voltage). The parame­
ter "Behaviour after voltage re­
turn" must be set to "Configu­
red position".
Note: If the value is above the
set maximum brightness or
below the minimum bright­
ness, then the system will
switch to the appropriate limit
value.
If the switch­off warning is ac­
tive, then, during switch­off,
the systems dims to minimum
brightness within 30 seconds
and only then switches off. If
the parameter "Dim down
ramp" is configured as longer
than 30 s, then the length of
the dim down ramp is applied.
If, during the dim down opera­
tion, another command is gi­
ven, e.g. switch on or scene
recall, then the switch­off war­
ning stops and the command
is executed. A switch­off com­
mand restarts the time for the
switch­off warning.
Note: The set time apply to
operation using radio transmit­
ters. The device is switched
immediately when the Prog
button is pressed.
Specifies the priority for reca­
lling and removing a scene of
type Lock­out protection for
the channel.
Note: 1 is the highest priority
and 4 the lowest. 0 means no
priority.
Specifies the priority for reca­
lling and removing a scene of
type Forced position for the
channel.
Specifies the priority for reca­
lling and removing a scene of
type Wind alarm for the chan­
nel.
Specifies the priority for reca­
lling and removing a scene of
type Sun protection for the
channel.
10/15