Genius G60 Manual Del Usuario página 7

ENGLISH
6.3. OUTSIDE RELEASE DEVICE (optional)
When using the outside release device, fit the cable in the seat
before starting installation.
1) Release the carriage (see par. 7.4. point 3) and bring it to
the slot located on the upper part of the sliding guide.
2) Insert the cable end in the special red seat (fig. 11).
3) Move the carriage back towards the drive coupling unit
until the through hole on the carriage matches the slot and
insert the unsheathed cable (fig. 12).
4) Pull the cable out from the bottom part of the carriage.
5) Wind the cable around so that it is not a hindrance when
installing the sliding guide.
7. INSTALLATION
For safe work install the operator keeping the door completely
closed; use adequate fixing systems and anchorage points and
read all of this chapter before carrying out installation.
7.1. SLIDING GUIDE
After completing the preliminary assembly operations, install the
sliding guide, proceeding as follows:
1) Draw a vertical line on the lintel, corresponding to the centre
of the door (fig. 13).
2) Draw a horizontal line on the lintel, corresponding to the
max. height reached by the door during movement (see fig.
4 and 5).
3) Position the front connection fixing bracket with bottom edge
at least 5 mm above the intersection point of the lines and
centred with the vertical line (fig. 13). See par. 7.2. for correct
positioning of the bracket with respect to the connection
point on the door.
4) Mark the two fixing points.
5) Drill the holes and proceed with installation.
6) Position the sliding guide on the ground, perpendicular to
the door.
7) Lift the guide from the front connection and assemble the
connection with the fixing bracket using the special through
screw and nut (fig. 14).
Fig. 11
Fig. 12
16
ENGLISH
A
Fig. 13
Fig. 14