! WARNING
A SCUBA unit complying with the requirements of the EN 250 norm is not designed
to supply more than one diver at a time.
If the SCUBA unit is used simultaneously by more than one diver, breathing and cold
water performance may no longer satisfy the requirements set forth by EN 250 norm.
3. IMPORTANT WARNING REMINDERS
For your protection while using SCUBAPRO life support equipment, we call your attention
to the following:
1. Use the equipment according to the instructions contained in this manual and only after
having completely read and understood all instructions and warnings.
2. Use of the equipment is limited to the uses described in this manual or for applications
approved in writing by SCUBAPRO.
3. Cylinders must only be fi lled with atmospheric compressed air, according to the EN
12021 norm. Should moisture be present in the cylinder, beside causing corrosion of
the cylinder, it may cause freezing and subsequent malfunction of the regulator during
dives carried out in low temperature conditions (lower than 10°C (50°F)). Cylinders must
be transported according to local rules provided for the transport of dangerous goods.
Cylinder use is subjected to the laws regulating the use of gases and compressed air.
4. Equipment must be serviced by qualifi ed personnel at the prescribed intervals. Repairs
and maintenance must be carried out by an Authorized SCUBAPRO Dealer service
facility and with the exclusive use of original SCUBAPRO spare parts.
5. Should the equipment be serviced or repaired without complying with procedures
approved by SCUBAPRO or by untrained personnel or not certifi ed by SCUBAPRO, or
should it be used in ways and for purposes other than specifi cally designated, liability for
the correct and safe function of the equipment transfers to the owner/user.
6. If the equipment will be used in cold water (temperature lower than 10°C (50°F)) it will be
necessary to use a regulator suited for such temperatures.
! WARNING
Diving in cold water requires special equipment and techniques. Before diving in
cold water we strongly recommend you obtain adequate training from a recognized
training agency.
7. The content of this manual is based upon the latest information available at the time of
going to print. SCUBAPRO reserves the right to make changes at any time.
SCUBAPRO refuses all responsibility for damages caused by non-compliance with the
instructions contained in this manual. These instructions do not extend the warranty or the
responsibilities stated by SCUBAPRO terms of sales and delivery.
4. REGULATOR SYSTEM
A regulator system is required to reduce the pressure of the compressed air contained in
the cylinder to an ambient pressure in order to supply breathable air when needed. It is also
possible to connect pressure gauges (analog or digital), IP infl ators to supply buoyancy
compensators, dry suits and other devices to this system. The regulator system is composed
of a pressure reduction device and one or more breathing devices. In this manual, the
pressure-reducing device and the breathing device will be indicated, respectively, by the
terms "fi rst stage" and "second stage."
3