Filling With Water; Setting The Temperature; Dry Ironing - Sinbo SSI 2862 Manual De Uso

NOTE:
* This appliance is for household use only. Use iron only for its intended use.
* Please check the voltage of the iron if it is the same with the one in you home.
* To avoid a circuit overload, do not operate another high-wattage appliance on the same circuit.
* To protect against risk of electrical shock, do not immerse the iron in water or other liquids.
* After using, turn the temperature control knob off or to "MIN".
* Keep the cord away from the hot soleplate. Let iron cool completely before putting away.
* Always keep the instruction manual, in case the iron is passed to a third person, please hand
over the manual together.
HOW TO USE
* Remove any labels, stickers or protective foil that may be attached to the body or soleplate
of the iron before first use.
* The iron may give off some smoke and emit an odor when you first use. This will cease after
a short while. It is safe and will hot harm the performance of the iron.

FILLING WITH WATER

* Remove the mains plug from the wall socket before filling the iron.
* Set the steam button to position "0"or "
* Please fill your iron with normal tap water before using for the first time.
* Use the water beaker attached to fill clean tap water into water tank until "MAX" filling level.
* For refilling, you can also use tap water. However, if the water is very hard it is advisable to
use distilled water.
* Replace water inlet cover and dry the spilt water around the enclosure of the appliance.
* Do not fill the tank beyond the MAX indication.
* Do not put perfume, vinegar, starch, descaling agents, ironing additives chemically descaled
water or other chemicals in the water tank.

SETTING THE TEMPERATURE

Fabric
NYLON/ACRYLIC/ACETATE
SILK/RAYON/POLYESTER
WOOL/COTTON
LINEN
* Stand the iron on its heel and plug the power cord into wall socket.
* Turn the iron temperature control knob until you get the desired fabric/temperature setting.
We recommend using the above table as a guide.
* The temperature pilot light will light, indicating that the soleplate is heating up.
* When the pilot light goes out, the required temperature has been reached.
* The temperature pilot light will go on from time to time during ironing.

DRY IRONING

* For dry ironing, turn the steam control knob to "0"or "
flow if water is in the water tank.
* Turn the temperature control knob to select the desired fabric/temperature setting. The
" or " " and open the water inlet cover.
Temperature control
•
• •
• • •
MAX
" or "
- 7 -
".This will cut off the steam