IPC IWD-E Manual De Instrucciones página 25

Hidrolimpiadora murales por agua caliente
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 59
nozzle to clean the most
stubborn dirt.
!
Danger:
Aim the jet from a certain
distance to avoid damage
caused by the high pressure.
Do not aim the jet at people,
animals or electrical sockets.
STOPPING THE CLEANER
1)
Switch off the heating
system by turning the tem-
perature controller to pos. "0"
and the main switch to pos. "I"
(fig. 7A, B).
2) Let the cleaner run with cold
water only for at least 30 se-
conds to cool down the boiler.
3) After using with detergent,
flush out the intake circuit;
place the detergent suction
hose (fig. 9) in a tank of clean
water and let the pump run for
1 minute with the dosing tap
turned fully on.
Repeat the operation with
the detergent selector set
first to position 1 and then to
position 2.
4) Stop the cleaner by turning
the selector switch to pos. "0"
(fig. 7A).
5) Discharge the pressure
from the H.P. hose by pressing
the trigger on the gun.
6)
Disconnect the water clea-
ner from the mains electricity
supply via the omnipolar swi-
tch or by unplugging the plug
from the socket.
7) Turn off the water supply
tap (fig. 5A).
USE OF THE DOUBLE LAN-
CE (fig. 10)
The double lance allows the
operator to select a low or high
pressure jet. The pressure is
selected with the gun in pos.
1. High pressure: pos. 2. Low
pressure pos. 3.
!
Warning
- If the water cleaner is left,
even temporarily, turn it off by
using the omnipolar switch or
by unplugging the plug from
the socket.
- Water cleaners with the
"Total Stop" device should
English
be considered as off when
the omnipolar switch is in
the "O" position or the plug
is unplugged from the sock-
et.
- When the water cleaner is not
used, close the safety device
on the handle.(fig.11)
- Dry use of the water cleaner
causes serious damage to
pump gaskets.
REGULATING PRESSURE.
The pressure regulator, fig.
11, allows the operator to
adjust the working pressure.
When knob C is turned in
an anti-clockwise direction
(B) (minimum), the working
pressure is reduced.
Turn the tap clockwise again
to shut off the steam.
FIG. 9
FIG.10
- 25 -
FIG.11
FIG.12
Tabla de contenido
loading

Este manual también es adecuado para:

D 1710D 1712

Tabla de contenido