Intended Use; Clothing And Equipment; Preliminary Operations - IPC IWD-E Manual De Instrucciones

INTENDED USE

This appliance is intended exclusively for cleaning machines,
vehicles, buildings and general surfaces suitable for treatment
with a high pressure jet of detergent solution between 25 and
250 bar (360 - 3600 PSI).
This appliance has been designed for use with the detergents
supplied or recommended by the manufacturer. The use of
other detergents or chemicals may influence the safety of the
appliance.
This appliance must be used only for the purpose for which it
was specifically designed.
All other uses are to be considered incorrect and therefore
unreasonable.
Examples of unreasonable use:
- Washing surfaces not suitable for cleaning with a high
pressure jet.
- Washing people, animals, electric equipment or the machi-
ne itself.
- Using unsuitable detergents or chemicals.
- Blocking the trigger (lever) of the lance in delivery posi-
tion.
The manufacturer cannot be held responsible for any damage
due to improper, incorrect or unreasonable use. As far as safety
rules are concerned, the cleaners are manufactured according
to the European Standard.

CLOTHING AND EQUIPMENT

Wear safety shoes with non-slip soles.
Wear protective goggles or visor and safety
garments.
You are recommended to wear overalls to reduce the risk of
injury caused by involuntary contact with the high pressure jet.

PRELIMINARY OPERATIONS

UNPACKING
After unpacking, ensure that the cleaner is undamaged.
If in doubt, do not use the machine.
Contact your dealer.
Packaging (bags, boxes, nails, etc) is potentially dangerous and
should be kept out of reach of children. It should be disposed
of or retained in respect of national environmental legislation.
FITTING THE SEPARATE PARTS OF THE MACHINE
All the fundamental parts and safety devices of the machine are
assembled by the manufacturer.
For reasons of packing and transport, some secondary cleaner
parts are supplied separately.
The user must fit these parts as explained in the instructions
supplied in each assembly kit.
English
DATA PLATE:
The data plate bearing the main technical characteristics of your
cleaner is located on the trolley and is always visible.
!
Warning
When buying your cleaner, ensure that it has an identifica-
tion plate. If there is no plate, inform the manufacturer and/
or the dealer immediately. Machines without a plate must
not be used and the manufacturer declines all responsibi-
lity for them. Products without a plate must be considered
anonymous and potentially dangerous.
INSTALLATION ACCESSORIES
(Optional Accessories)
The "Murale" water cleaner can be wall mounted using special
brackets or a painted steel shelf type support with a leak-proof
stainless steel container to hold the detergent tanks.
WALL-MOUNTED INSTAL-
LATION.
The wall-mounted pressure
washer must always be in-
stalled on solid concrete or
masonry walls.
!
Danger
Never install the wall-mounted
pressure washer on plaster-
board or hollow brick partition
walls.
To secure the appliance to the
wall, use suitable devices ba-
sed on the tyre of construction
of the wall and the weight of
the pressure washer being
installed (see the table of te-
chnical specifications).
Install the wall-mounted pres-
sure washer at a height of at
least 1 m above the ground,
protected against dripping or
water spray.
- 22 -
FIG. 1