Simu Hz Manual Del Usuario página 3

Hz RECEIVER
EN
S.A.S. au capital de 5 000 000 € - Z.I. Les Giranaux - BP71 - 70103 ARC-LÉS-GRAY CEDEX - FRANCE - RCS VESOUL B 425 650 090 - SIRET 425 650 090 00011 - n° T.V.A CEE FR 87 425 650 090
SIMU hereby declares that the radio equipment covered by these instructions is in compliance with the requirements of Radio Directive 2014/53/EU and the other
essential requirements of the applicable European Directives. The full text of the EU declaration of conformity is available at www.simu.com.
i Description of Hz receivers
Hz receiver
for T3.5/T5/T6 wired Motor
antenna
(equipped with connexion
kit (9011670))
Hz receiver for
T5 AUTO/T5 E
Motor.
Installation
1
Instructions which must be followed by the drive and home automation professional installing the drive:
- Methods of wiring are given by national standards or IEC60364 standard.
- Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve. The cable may only be connected
to the motor by qualified personnel. The connector is to be assembled without damaging the contacts. The continuity of the earth
connection must be ensured.
Protection device: No integrated protection device. A suitable all-pole cut-off device must be installed upstream in the electrical instal-
lation in accordance with the wiring rules (minimum contact opening distance of 3.5 mm).- Glow wire temperature: 750 °C - Proof
tracking index: ≥100 V.
Recommendations:
- Hz receivers are designed for use in 150 to 205-mm Mini 45° SIMBAC® consoles.
- Keep a minimum distance of 20 cm between two Hz receivers. Keep a minimum distance of 30 cm between Hz receivers and Hz
transmitters. Hz receivers should preferably be placed at a minimum height of 1.5 m from the floor.
- Do not roll up or cut the antenna of an Hz receiver. Do not immerse Hz receivers in water.
- While assembling the casing, take care not to drill through the Hz receiver.
- A radio appliance using the same frequency (433,42MHz) may deteriorate our product's performance (ex.: hi-fi radio headphones).
Installing an Hz receiver with an T3.5/T5 or T6 motor (equipped with connexion kit 9011670):
1
Installing an Hz receiver for an T5 AUTO or T5 E motor:
1
45 120 24
0,20m 3,00m
3
4
2
3
4
2
Compatible transmitter (max. 12 per receiver):
1 : Wall transmitters: 1 /5 channels/Hz MEMORY transmitter/Hz Sequential
transmitter
2 : Hz mobil 1/5 channels transmitter
3 : Hz transmitters: Color Multi / Timer-Easy / Timer-Multi
230V~50Hz
4 : Hz Sun Sensor
brown
L
1
N blue
yellow/green
Location of the PROG button on Hz transmitters:
IP44
+80C
-30C
PROG
5c
5a
5c
5b
5a
5b
Read carefully these instructions
3
2
Transmitters range :
5
5008029G
before any use.
4
15m max.
20m max.
6m max.
6
90
6
1/ 2