Cembre HT131-U Manual De Uso página 5

3.3) Crimping
– Continue operating the moveable handle (53). The tool will automatically change over to the
high pressure stage. The ram will advance until the dies meet.
– It is recommended to continue pumping until the maximum pressure valve is activated and a
"click" is heard.
3.4) Dies re-opening
– Rotate main handle to release position
Completely close handles and the die will retract.
3.5) Rest setting
– Completely retract the ram as § 3.4.
– Close handles and rotate main handle to rest position
locked.
– Store the tool in the plastic case.
4. CRIMPING OF CONNECTORS ON COPPER CABLES
4.1) Connector crimping
– Fit adaptor AU130-C (see § 4.2).
– Select the appropriate die set for the connector.
– Insert die set in to upper and lower die holders (see § 4.3).
– Insert the conductor in the connector.
– Position the connector between the dies and ensure the correct location of the crimp.
– To crimp connector continue as § 3.2.
4.2) Adaptor assembly
Insert the AU130-C (90) adaptor in the guides on the U-fork (33) until securely located, with the
grooves on the adaptor corresponding to the locators (34) on the U-fork head (33).
Remove the adaptor by pushing the adaptor off the locators and sliding from the head.
4.3) Dies assembly
4.3.1) Press release button (86) and insert the upper die (88) into the AU130-C adaptor (90) until
secured by the die retaining pin (87).
To remove the upper die, press the release button (86) and slide the die from the adaptor (90).
4.3.2) Press the release pin (30) and insert the lower die (89) into the seat on the ram (28) until
secured by the pin (32). To facilitate this operation an advancement of 15-20 mm (0.59 - 0.79 in.) of
the ram (28) is suggested. To remove the die press the release pin (30) and slide the die from the
ram.
5
.
; the moveable handle will be
(Ref. to Fig. 2 and 3)
ENGLISH