Whittier Wood Products 232W Instrucciones De Montaje página 7

F
x 12
G
x 8
Front
FIG. 11A
11. Install three Drawer Slides (Cabinet Side Left) (E2) using Screw (F) into the small predrilled holes
in the Thin Set of Slide Supports (D & C). Use the first hole behind the slide wheel and the last
hole on the slide. Make sure the slide wheels face out as shown in FIGURE 11A.
Repeat and install three Drawer Slides (Cabinet Side Right) (E1) onto the Thick Set of Slide
Supports (B & A). Make sure the slide wheels face out as shown in FIGURE 11B.
12. Tap in the Wood Dowels (G) into the larger holes on each Slide Support (D, C, B & A) as shown
in FIGURE 11A & B. Start from the side that has the drawer slides and tap the dowel out the
other side until 1/4" of the dowel is showing. Do not glue dowels.
H
x 8
Vertical
Divider
FIG. 13A
13. The left side support assembly (D & C) needs to be installed on the vertical divider. See
FIGURE 13A. The right slide support assembly (B & A) needs to be installed on the right side of
the right shelf compartment. See FIGURE 13B.
To do so, align the four wood dowels that extend from the opposite side from the slides into the
column of holes in the base unit normally used for the adjustable shelves. This should be the top
most and bottom most holes in each column of holes. Once the slide support assembly is flush
with the side of the base unit, secure assembly using Screw (H) in the holes as show in FIGURE
13A & 13B.
G
E2
F
Thin
Set
E2
F
G
E2
F
H
H
H
H
G
G
E1
F
F
Thick
Set
F
F
G G
Rear Rear
E1
F
F
G
F
E1
F
G
Front
FIG. 11B
F
H
H
H
H
DO NOT
GLUE
DOWELS
DO NOT
GLUE
DOWELS
Right Side
Panel
FIG. 13B
232W/243W — Page 7