Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To reduce the risk of serious personal injury, turn unit off and
remove the battery pack before making any adjustments
or removing/installing attachments or accessories, when
replacing line or prior to cleaning. An accidental start-up can
cause injury.
Accessories
Since accessories, other than those offered by the
manufacturer, have not been tested with this product, use of
such accessories with this tool could be hazardous. To reduce
the risk of injury, only original equipment manufacturer (OEM)
recommended accessories should be used with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
Please see the separate supplement for contact information and
replacement parts.
Replacement Accessories
To reduce the risk of serious personal injury, turn appliance
off and remove battery before making any adjustments or
removing/installing attachments or accessories.
The use of any accessory not recommended by the original
manufacturer for use with this appliance could be hazardous.
DO NOT use any blades, or any accessory or attachment other
than those recommended by the original manufacturer on this
trimmer. Serious injury or product damage may result.
When replacing the line, use .080" (2 mm) or 0.095" (2.4 mm)
diameter line. Use original manufacturer replacement line (see
separate supplement). Other sizes may degrade performance or
cause damage to the trimmer.
Replacing Spool Assembly (Figure 15 & Figure 16)
1.
Rotate the spool housing (9) until the hole (24) in the
spindle plate aligns with notch (25) in the housing. Insert
a screwdriver through the notch and into the hole, to
prevent the spindle (26) from turning.
2.
Unscrew and remove the spool housing by turning the
spool grip cover (20) clockwise.
NOTE:
DO NOT try to remove the spool housing by turning the spool
head (30).
MAINTENANCE
WARNING
WARNING
WARNING
WARNING
WARNING
3.
Remove
spindle plate
(27) before
installing a
new housing.
Remove
any dirt and
grass from
the motor
housing and
spindle plate.
4.
Install
spindle plate
onto the
spindle, so the
double D shaped
retaining nut on
the spindle sits
inside the base of
the spindle plate.
5.
Align the spindle
plate hole and
notch, insert
a screwdriver
back into the
hole and thread
the new spool
housing counter-
clockwise. Securely tighten the new spool housing onto
the spindle.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
Please see the separate supplement for additional information.
Cleaning
Blow dirt and dust out of all air vents with clean, dry air at
least once a week. To minimize the risk of eye injury, always
wear ANSI Z87.1 approved eye protection when performing
this procedure.
Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken
the plastic materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get inside
the tool; never immerse any part of the tool into a liquid.
15
24
20
30
Figure 15
Figure 16
WARNING
WARNING
25
27
26
9
26
30
Tabla de contenido
