Switching The Device On/Off; Servicing; Cleaning The Trimmer - Wolf Garten LYCOS E/500 T Manual De Instrucciones

Servicing

Mains socket connection (230 V, 50 Hz)
Risk of injuries or material damage.
Observe the mains voltage.
The power source voltage must
match the information on the device
Only connect to a socket, that is
(or an MCB).
Note
into contact with damaged/bare wires, if an
occurs.
• We recommend that you only connect the
device to power outlets that are protected by
a residual current device (RCD) with a tripping
• For older wiring installations, upgrade kits are

Switching the device on/off

Risk of injuries due to the rotating line.
Tool continues running!
Always wait until the cutting tool comes
to a standstill.
Hold the trimmer parallel to the lawn
before switching on.
Switching the device on
Press the lock-on switch on the handle
handle .
Release the lock-on switch again.
The device operates.
.
Note
The cutting tool continues to run for a brief
WARNING!
WARNING!
Adjusting the line
Typ 1
e.g. a paving stone using the press knob (pressing
down force about 3 kg). About 1.5 cm of cutting
line is automatically fed out.
Typ 2
automatically out of the line box.
Note
son results in increased line wear.
Note
If the cutting line becomes too short during
Risk of injuries or material damage.

Cleaning the trimmer

.
tool comes to a standstill.
Clean the device with a hand brush after every
use.
Clean the ventilation slots and underside of the
device at regular intervals to remove grass resi-
dues.
Do not clean the device with water.
Servicing
WARNING!
Only clean or service the device if the
motor is stationary and also the cutting
tool.
Pull out the mains plug before any work
on the device!
Repair and service work as well as the
replacement of safety elements must
workshop.
Attention!
EN
-
-
23