DeWalt DXAM2818 Manual De Instrucciones página 7

Once the unit is plugged in, the air mover can be turned on by rotating the
switch to one of the settings shown below.
O (OFF) III ( HIGH )
AIR MOVER OPERATING POSITIONS
The air mover may be set in one of two operating positions. Pick
the position best suited for the application.
•
Use the down position (Figure 2) for applications such as: drying wet oors,
shampooed carpets, etc. To use this position simply place unit on its base.
•
Use the up position for applications such as: drying paint on the ceiling.
To use this position, lay the unit on the back side with the front grill pointing
towards the ceiling (Figure 3).
Figure 2
II (MEDIUM) I (LOW)
Figure 3
UNPACKING AND CHECKING CARTON
CONTENTS
Carefully unpack and inspect Air Mover. Contact customer service if
any parts are damaged or missing.
This Air Mover includes a retractable handle. It is shipped in its locked
lowest position.
Retractable
Handle Down Position
Handle
Locked
Unlock the levers and adjust
handle to desired height
Tightening the Handle:
•
If handle does not hold its position after engaging the lock levers,
unlock the handle so adjustments can be made.
• Slightly tighten the hex nut (A) and re-engage the lock levers.
If still not satisfactory, repeat this step until desired lock force
is achieved. DO NOT OVERTIGHTEN.
Close
A
Open
7
Handle Up Position
Retractable
Handle
Unlocked
Adjust handle to desired
height and lock into place
with levers