Worx MakerX WX746L Manual De Instrucciones página 9

2. Press the power button until the light goes out. Then press the on/off switch
on the hub to turn off after use.
NOTE: In order to save energy, the glue gun switches off automatically after 10
minutes.
NOTE: Put down the glue gun in a safe way and allow it to cool down completely
before packing it away after each use.
MAINTENANCE
Remove the battery before carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage your power tool.
Store the accessories in a dry place.
WARNING
: Do not use inflammable solvents for cleaning the surfaces
to be glued. For excess hardened glue, it can be removed with a blunt
object. Do not use solvent for cleaning.
TROUBLESHOOTING
Problems
No glue comes out.
Glue stick falls out
from the tool.
There is glue leaking
out without trigger
pressed after use.
Trigger is blocked for
glue escaping toward
the rear.
Possible Causes
Glue stick is used up.
Glue stick diameter is too
large or small.
Glue stick is not pushed to
the end.
Glue stick diameter is too
small.
The temperature is still
high in short time after use
and will cause glue melted.
Glue stick diameter too
small.
Glue stick's melting
temperature is too low.
Possible Solution
Insert a new glue stick.
Use recommended glue
sticks.
Push the glue stick to the
end when loading.
Use recommended glue
sticks.
It is normal and will stop
leaking out when the
glue gun cools down.
Use recommended glue
sticks.
EN
9