How It Works - Blue Lagoon Timer UV-C0W Manual Del Usuario

TIMER UV-C

HOW IT WORKS

EN
Inside the reactor a UV-C lamp produces radiation with a wavelengthf 253.7 nm. Radiationf this type kills
bacteria, viruses, algae and fungi (e.g. Legionella and Cryptosporidium). The UV-Cnit produces clean,
fresh, clear water in an efficient, environmentally friendly way. The water is fed through the UV-C device
by a pump. The UV-C radiation neutralizes bacteria, viruses andther micro-organisms and prevents them
from reproducing. Floating algae is also destroyed by this radiation, which greatly improves the clarityf
the water. The UV-Cnit is equipped with an electronic ballast. This ballast ensuresptimum performancef
the lamp.
In addition, the stainless steel reactor reflects the UV-C radiation, increasing efficiency byp to 35%.
Thanks to the UV-Cnit, the water is disinfected efficiently and safely, providing you with excellent water
quality. Overdosing with UV-C is not possible.
INSTALLATION OF EARTHING (DRAWING)
1. Before the plastic strain relief (4) is fittedn the earthing bolt (1), first pull the cable (2) through the
strain relief (4). Place the strain relief (4) about0 cm from the eye (2)f the earthing cable.
2. Place the eye (2)f the cablever the earthing bolt that is attached to the housing.
3. Then place a serrated lock washer (3).
4. Attach the strain relief (4) to create a Ø5 cm loop.
5. Finally, place the second serrated lock washer (5) and the lock nut (6)n the earthing bolt.
6. Once the parts have been placedn the earthing bolt in the correctrder, it can be tightened with an 8
mmpen-endr ring spanner.
WARNING:
DEVICE INSTALLATION (FIGURE 2)
Decide where you want to mount the device. Never install the UV-Cnit after the pH controller, chlorine
dispenserr salt electrolysis system in the swimming pool installation. The best place to install the device
is directly after the filter. See the schematic diagram in theperating instructions. Make sure there is always
water flowing through the device when the lamp isn. Never install the device in direct sunlight. Install the
device in a dry, well-ventilated area. The device can be installed either horizontallyr vertically, provided
that the water flow is from bottom to top (see schematic diagram at the beginningf the instructions
forse), with 30 cmfnobstructed spacen the sidepposite the lamp connection for future maintenance. At
leastne metrefnobstructed space must be leftn the side with the lamp connection for convenient future
replacementf the lamp (K) without having to disconnect the entire device.
CAUTION: All connections and couplings must be hand-tight. Do not tighten them with tools.
8 | TIMER UV-C
Please read through these instructions forse
carefully before installing this device.
Always ensure proper earthing. In casef doubt about the earthingr the electrical installation
in general, always consult a qualified electrician. Incorrect earthing can be dangerous and/or
lead to corrosionf stainless steelr aluminium reactors.
Make sure the reactor is always grounded.