Virutex AS182K Manual De Instrucciones página 7

Connect the aspirator plug to the mains and turn
switch H (Fig. 2) to position "II".
In these conditions each time the tool is started the
aspirator will also be automatically started.
If, on connecting a electronically regulated portable
machine to the aspirator, you should notice that the
aspirator does not start up automatically when the
machine is turned on, just turn the connection plug
of the machine in the aspirator through an angle of
180° to rectify the problem.
The "Y" connection makes it possible to use up
to two power tools simultaneously with only one
aspirator.
7. INSTRUCTION TO BE STRICTLY FOLLOWED
• The use of this machine for anything not speci-
fied in this manual may be dangerous and must be
avoided.
• The suction nozzle should be kept away from the
body, especially delicate areas such as the eyes, ears
and mouth.
• The equipment should be correctly assembled
before use.
• Ensure that power sockets used are correct for
the machine.
• Check the voltage indicated on the rating plate is
the same as the supply voltage.
• These machines are not designed for picking up
health eddangering dusts or inflammable/esplosive
substances.
• Never leave the equipment unattended whilst
in use.
• Never carry out any maintenance on the machine
without first disconnecting from the mains supply, if
the machine is to be left unattended or can bereached
by childrens or others persons not aware about their
action, the supply should also be terminated.
• The main supply cable should not be used to pull
or lift the machine.
• The machine should never be emersed in water or
a pressure jet of water used for cleaning.
• Periodically examine the mains cable and machine
for damage. If any damage is found contact your
service centre for repair.
• Should extension cables be used, ensure that the
cable rating is suitable for use with the equipment.
Do not use the cable coiled as this could result in a
voltage drop or overheating. Keep dry at all times.
• The equipment should not be used to pick up water
from containers lavatories, tubs, etc.
• Ensure that the float I (Fig. 4) is not damaged or
obstructed by anything that may stop it from rising.
The floats function is to stop the suction when
the tank is full or if the machine should overturn
accidentally.
• If the equipment should overturn it is recommen-
ded that the machine should be stood up before
switching off.
• If foam / liquid should come from the machine
exhaust switch off immediately.
• Aggressive solvents or detergents should not be
used.
• The manufacturer cannot be held responsible for
any damage/injury caused to persons or property,
because of the incorrect use of the machine due to
procedures being used which are not specified in
this instruction manual.
8. MAINTENANCE
Before carrying out any work on the aspirator remove
the plug from the mains.
All work carried out on the machine must be done
by qualified technicians.
To ensure the machine is kept in good working order
we recommend you:
- Regularly remove dust and dirt by shaking out the
filter bag. Regularly clean the filter cartridge with
a soft-haired brush.
The filter cartridge must be discarded when exces-
sively encrusted or damaged, and replaced with a
new filter.
It is recommended to keep a spare filter handy.
- Always keep the aspiration pipes clean (too much
dirt causes loss of aspiration and overheating of
the motor)
-The rotating parts of the machine do not need any
lubrication as they are equipped with auto-lubricating
bearings. The thickness of the carbon brushes on
the motor must be checked, in normal conditions,
every 12 months or changed when they are reduced
to 9 mm thick.
9. WARRANTY
All VIRUTEX power tools are guaranteed for 12
months from the date of purchase, excluding any
damage which is a result of incorrect use or of natural
wear and tear on the machine. All repairs should
be carried out by the official VIRUTEX technical
assistance service.
10. RECYCLING ELECTRICAL EQUIPMENT
Never dispose of electrical equipment with domestic
waste. Recycle equipment, accessories and packaging
7