Uline H-7741 Manual Del Usuario página 6

Acrylic Panel x 1
1. Place desk frames together. Align dual bracket
with holder with holes on top of support frames and
attach using four M6 x 15 mm bolts. Repeat for
remaining dual brackets with holder. Insert acrylic
panel into dual brackets with holder. Align dual
bracket with holes on top of leg frames and attach
using four M6 x 15 mm bolts. Repeat for remaining
dual brackets. (See Figure 13)
Figure 13
M6 x 15 mm
NOTE: Additional Back-to-Back sets can be
added to create longer configurations. To
extend workstation, attach dual brackets to
end of desks and connect additional sets
during this step.
PAGE 6 OF 24
BACK-TO-BACK WORKSTATION PARTS LIST
Dual Bracket with Holder x 2
BACK-TO-BACK WORKSTATION ASSEMBLY
Bolt
Dual Bracket
Dual Bracket
with Holder
Dual Bracket x 2
2. Place tops over frames. Align holes on tops with
holes on frames and attach using M6 x 60 mm bolts.
(See Figure 14)
NOTE: Parts from page 1 will be used during this
step.
Figure 14
3. Align holes on modesty panel with holes on legs and
attach using four M6 x 15 mm bolts. Insert black or silver
grommets based on preference. (See Figure 15)
Figure 15
M6 x 15 mm Bolt x 16
Modesty Panel
Attachment
0421 IH-7741