Package Contents; Description (Fig. A) - DeWalt DW340K Manual De Instrucciones

E N G L I S H
Check for misalignment and seizure of moving
parts, breakage of parts and any other conditions
that may affect its operation. Have damaged
guards or other defective parts repaired or
replaced as instructed. Do not use the tool if the
switch is defective. Have the switch replaced by
an authorized D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Additional safety instructions for heatguns
General
• Do not place your hand over the air vents or
block the vents in any way.
• The nozzle and accesories of this tool become
extremely hot during use. Let these parts cool
down before touching.
• Always switch the tool off before putting it down.
• Do not leave the tool unattended while it is
switched on.
• A fire may arise if the appliance is not used with care.
• Heat may be conducted to combustible materials
that are out of sight. Do not use in a damp
atmosphere, where flammable gases may be
present or near combustible materials.
• Allow the tool to cool fully before storing.
• Ensure adequate ventilation as toxic fumes may
be produced.
• Do not use as a hairdryer.
• Do not obstruct either the air intake or nozzle
outlet, as this may cause excessive heat build up
resulting in damage to the tool.
• Do not direct the hot air blast at other people.
• Do not touch the metal nozzle as it becomes very
hot during use and remains hot for up to
30 minutes after use.
• Do not place the nozzle against anything while
using or immediately after use.
• Do not poke anything down the nozzle as it could
give you an electric shock. Do not look down the
nozzle while the unit is working because of the
high temperatures being produced.
• Do not allow paint to adhere to the nozzle or
scraper as it could ignite after some time.
en - 3
Removing paint
• Do not use this tool to remove paint containing
lead. The peelings, residue and vapours of paint
may contain lead, which is poisonous.
Any pre-1960 building may have been painted in
the past with paint containing lead and covered
with additional layers of paint. Once deposited on
surfaces, hand to mouth contact can result in the
ingestion of lead. Exposure even to low levels of
lead can cause irreversible damage to the brain
and nervous system. Young and unborn children
are particularly vulnerable.
• When removing paint, ensure that the work area
is enclosed. Preferably wear a dust mask.
• Do not burn the paint. Use the scraper provided
and keep the nozzle at leat 25 mm away from the
painted surface. When working in a vertical
direction, work downwards to prevent paint from
falling into the tool and burning.
• Dispose of all paint debris safely and ensure that
the work area is thoroughly cleaned after
completing the work.

Package contents

The package contains:
1 Heatgun
1 Set of accessories
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your D WALT heatgun DW340K has been designed
E
for stripping paint, soldering pipes, shrinking PVC,
welding and bending plastics as well as general
drying and thawing purposes.
1 On/off switch
2 Air vents
3 Stand locations
4 Air temperature adjustment knob
5 Nozzle
16