Idiomas disponibles
Idiomas disponibles
This cable simplifies the installation of a 55020/55021 Multi-
Train System Decoder in LGB locomotives with a decoder
interface. If this cable is used, it is usually not necessary to
replace the voltage sensitive components, like light bulbs
and smoke generators. Locos with a decoder interface are
marked with a round black sticker with six white dots on the
bottom of the loco.
INSTALLATION
These instructions are only a general guide. The specific
instructions for individual products will vary. Attention!
Improper installation may void your warranty. Attention! Do
not apply power to the model until the installation is comple-
te. Electronic components may be damaged.
- Disassemble the model to expose the main circuit board.
- Find the miniature switches on the main circuit board. Set
all the switches to the OFF position. Hint: Some LGB locos
have additional switches for controlling sounds. These
switches do not have to be reset.
- Attach the four decoder wires to the matching pins on the
main circuit board. The color codes are: gn = green,
bn = brown, ws = whit,e gb = yellow
Hint: On some LGB locos these pins are identified with
colored rings around the pins. On some locos these pins are
identified with printed letters on the main circuit board.
- Find the 6-pin interface cable block on the main circuit
board. Insert the interface cable plug into the block.
- Attach the interface cable wires to the matching pins on
the decoder. The color codes are: bl = blue,
rt = red, gb = yellow, gr = green, or = orange, bn = brown
- Reassemble and test the model.
Hint: Test the model with a low-power supply, like a starter
set power pack. If there is a wiring error, this will reduce the
chance of damage.
3
