Uline H-5615 Guia De Inicio Rapido página 3

GATE WIDTH ADJUSTMENT
DANGER! A fall resulting in DEATH or SERIOUS
INJURY may occur if gate is improperly
installed or used. Gate width MUST be set for
gate strike plate to overlap structure opposite
the gate mount so the outside edge of gate
strike plate is aligned past the center of
guardrail tube, as illustrated in Figures 2 and 3.
Gate width is adjustable in two inch increments.
1. Remove gate sleeve hex head cap screws and
locknuts from gate sleeve and tube panel.
2. Slide gate tube panel in or out to set position.
Make sure the gate tube panel gate strike plate is
positioned as shown in Figure 2.
Inspect gate for any permanent deformation,
corrosion, degradation, failure of the gate to fully close
automatically or any condition impairing protective
capability.
PAGE 3 OF 9
INSTALLATION CONTINUED
3. Align holes in gate tube panel and gate sleeve.
4. Replace cap screws through aligned holes.
5. Replace locknuts and fully tighten.
6. Open gate and let close. Make sure gate fully
MAINTENANCE
1-800-295-5510
uline.com
closes automatically and stops in closed position as
illustrated in Figure 2.
DANGER! A fall resulting in DEATH or SERIOUS
INJURY may occur if gate is improperly
installed or used. Do not use gate unless gate
tube panel and the cap screws are in place
and locknuts are securely tightened.
DANGER! A fall resulting in DEATH or SERIOUS
INJURY may occur if gate is improperly
installed or used. If any of the conditions are
suspected, barricade from use with warnings
prohibiting use prominently displayed until
gate can be replaced.
0521 IH-5615