Volpi Kamikaze KV4 Manual Del Usuario página 39

13.1 Tying procedure
•
When the equipment is operating, keep your other hand at least 5cm away from the area of
tying mouth; don't place your hand in the tying mouth.
•
Don't use the equipment to tie the branches with a diameter more than 25mm, otherwise the
machine may get stuck. During tying operation, the tying machine has to be be vertical to
branches, and don't tilt or move during tying process. The damage of the equipment caused by
incorrect operations is not covered by quality warranty.
•
Don't use the equipment during rainy days.
•
After daily usage, it is suggested to disconnect the battery to the machine and place them
together in the toolbox.
•
According to the size of actual branches to be tied, adjust gear switch with the buttons place on
the tying machine, so as to achieve the best branch-tying effect.
•
Place the hook in the correct position according to the picture, you should always put the
branch attached to the outer end of the hook, never attached to the tying helix
No. on display
3
4
5
6
7
8
In case tying operation speed becomes slow, please check if battery charge is used up.
Correct branch position
Maximum Ø with plastic wire
25mm
25mm
24mm
22mm
20mm
16mm
Incorrect branch position
Maximum Ø with paper wire
24mm
22mm
18mm
14mm
Not recommendable
Not recommendable
39