Hyper Tough HT19-401-003-03 Manual Del Operador página 12

Problems
Trimmer fails to operate.
Trimmer runs intermittently.
Excessive vibrations/noise.
Cutting time per battery charge too
short.
Machine does not cut.
Continuous lighting of the battery
charge indicator.
No charging procedure possible.
Command feed does not work
Possible Causes
Battery discharged.
Battery too hot/cold.
Motor is broken.
Internal wiring of machine damaged.
Motor is broken.
Battery not fully charged.
On/Off switch defective.
Machine defective.
Line spool is not wound well.
Battery has not been used for long
period or only charged for short term.
Grass too high.
Battery defective.
Line broken.
Battery not fully charged.
Motor is broken (speed is too low).
Grass entangled around cutting head.
Battery not (properly) inserted.
Battery contacts contaminated.
Battery defective.
Cutting line is not wound well.
The line is tangled.
Line is used up.
12
Corrective Action
Recharge battery; also see
the content in charger manual.
Allow to cool/warm.
Contact Service Agent.
Contact Service Agent.
Contact Service Agent.
Recharge battery.
Contact Service Agent.
Contact Service Agent.
Rewind the line. See '' To fit spool
and line assembly. ' '
Fully charge battery; also see the
content in charger manual.
Cut in stages.
Replace the battery.
Replace the line.
Recharge battery; also see the
content in charger manual
Contact Service Agent.
Remove grass.
Properly insert battery into battery
charger.
Clean the battery contacts or
replace the battery.
Replace the battery.
Manually feed the line, if still can
not feed out, remove the Spool out
and rewind the line.
Replace with a new spool of line.