For Charger Acg318W1U; For Charger Ht19-401-003-13; Charging Indicator - Hyper Tough HT19-401-003-03 Manual Del Operador

CHARGING PROCEDURE (SEE FIG. F3)
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the charging process has started.
3) When charging is completed, the light will turn to green. The pack is now fully charged, unplug the charger
and remove the battery pack.
WARNING:
When battery charge runs out after continuously use or exposure to direct sunlight or heat,
allow time for the tool to cool down before re-charging to achieve the full charge.

CHARGING INDICATOR

Light
Red on
Green on

FOR CHARGER ACG318W1U

CHARGING PROCEDURES (SEE FIG. T)
Connect the battery charger to the power supply and the indicator light should turn to green. Then, slide the
charger base on the battery pack to make connections and the indicator light will turn red to show that the
charging has started. It will remain red until the battery is fully charged.When charging is completed, unplug
the charger and remove the battery pack.
CHARGING INDICATOR
Light
Red on
Green on

FOR CHARGER HT19-401-003-13

IMPORTANT NOTES FOR CHARGING BATTERY
The battery charger supplied is matched to the Li-ion battery installed in the machine. Do not use another
battery charger.
The Li-ion battery is protected against deep discharging. When the battery is empty, the machine is
switched off by means of a protective circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the battery pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
When the battery pack is charged for the first time and after prolonged storage, the battery pack will accept
a 100% charge after several charge and discharge cycles.
CHARGING PROCEDURE (SEE FIG. U)
1) Plug the charger into an appropriate outlet. The light will be green.
2) Slide the battery pack into the charger, the light will turn to red to indicate the charging process has
started.
3) When charging is completed, the light will turn to green. The pack is now fully charged, unplug the
charger and remove the battery pack.
WARNING: When battery charge runs out after continuously use or exposure to direct sunlight or heat, allow
time for the tool to cool down before re-charging to achieve the full charge.
CHARGING INDICATOR
Light
Red on
Green on
Status
Charging
Fully Charged
Status
Charging
Fully Charged
ON/OFF flash
10
Status
Charging
Fully Charged