Cleaning Agents; Faults And Repairs; Malfunction Table - NEFF C54L60W0 Instrucciones De Uso

:
Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, or sharp or abrasive
cleaning aids or detergents.
Notes
Slight differences in colour on the front of the appliance are
■
caused by the use of different materials, such as glass,
plastic and metal.
Shadows on the door panel which look like streaks, are
■
caused by reflections made by the oven light.
Enamel is baked on at very high temperatures. This can
■
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
Unpleasant odours, e.g. after fish has been prepared, can be
■
removed very easily. Add a few drops of lemon juice to a cup
of water. Place a spoon into the container as well, to prevent
delayed boiling. Heat the water for 1 to 2 minutes at
maximum microwave power.

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use
sharp or abrasive cleaning agents,
■
metal or glass scrapers to clean the glass in the appliance
■
door,
metal or glass scrapers to clean the door seal,
■
any coarse scouring pads or cleaning sponges,
■
cleaning agents with high concentrations of alcohol.
■

Faults and repairs

It is not always necessary to call the after-sales service.
Sometimes, you can find a remedy yourself. You will find some
tips for troubleshooting in the following table.

Malfunction table

Problem
The appliance does not work
Three zeros appear in the display.
The appliance is not in operation. A
cooking time appears in the dis-
play.
The microwave does not switch on. The door was not fully closed.
26
Possible cause
Faulty circuit breaker
Plug not plugged in
Power cut
Incorrect operation
Power cut
The button was not pressed after the set-
...
ting had been made.
The button has not been pressed.
...
Wash new sponge cloths thoroughly before use.
Area Cleaning agents
Appliance front Hot soapy water:
Clean using a dish cloth and then dry
with a soft cloth. Do not use glass clean-
ers or metal or glass scrapers for clean-
ing.
Stainless steel Hot soapy water:
Clean using a dish cloth and then dry
with a soft cloth. Remove flecks of
limescale, grease, starch and albumin
(e.g. egg white) immediately. Corrosion
can form under such residues. Special
stainless steel cleaning agents can be
obtained from the after-sales service or
from specialist retailers.
Cooking compart- Hot soapy water or a vinegar solution:
ment made of stain- Clean using a dish cloth and then dry
less steel with a soft cloth.
If the oven is very dirty: use oven
cleaner, but only when cooking com-
partment is cold. It is best to use a stain-
less-steel sponge. Do not use oven
spray or other aggressive oven cleaners
or abrasive materials. Scouring pads,
rough sponges and pan cleaners are
also unsuitable. These scratch the sur-
face. Allow the interior surfaces to dry
thoroughly.
Door panels Glass cleaner:
Clean with a dish cloth. Do not use a
glass scraper.
Door seal Hot soapy water:
Do not remove. Clean with a dish cloth; do not scrub. Do
not use a metal or glass scraper for
cleaning.
Remedy/information
Look in the fuse box and check that the circuit
breaker for the appliance is in working order.
Plug in the plug
Check whether the kitchen light works.
Switch off the circuit breaker in the fuse box.
Reconnect it after approx. 10 seconds.
Reset the clock.
Press the
...
Check whether food residues or foreign objects
are trapped in the door. Make sure that the seal
surfaces are clean. Check whether the door seal
is twisted.
Press the
...
button or switch the appliance off.
button.