Mounting The Handle; Putting The Appliance Into Operation; Electrical Connection; Removing The Shelves - Kuppersbusch EWK880-0-2Z Instrucciones De Uso

Installation
The appliance must stand upright for 24 hours before it is put
into operation.

Putting the appliance into operation

Remove the external and internal packaging and clean the outside of
the appliance with a clean, dry cloth. Clean the interior with a soft,
damp cloth.
Your appliance will operate best and use the least amount of energy
if you do not install it near a source of heat (heater, cooker, etc.), if it is
not subjected to direct sunlight and if it is not installed in a room that is
too cold. The surrounding temperature must be in the range of +16 °C
and + 38 °C.
For appliances that cannot be built in or appliance without front
ventilation, a clearance of 70 mm must be maintained between the wall
the sides and the back and top of the appliance. Do not cover this
clearance and do not put anything into it as the appliance will not
function properly if the air cannot circulate. The appliance must stand
horizontally and be wedged to prevent movement and resulting noises.
It must be possible for air to circulate freely on the front of the
appliance.
The user alone will be liable for faults caused by failure to comply with
the installation instructions.
Your wine refrigerator is fitted with a reversible door. Should you wish
to change the opening direction, please following the instructions in
section "Changing the Door Hinge", page 16.

Electrical connection

The appliance is fitted with a mains cable and a plug for 230 V single
phase / 50 Hz according to the EC directive. It is absolutely essential to
connect the appliance to an earthed wall socket with protection again
at least 5 A. Insert the mains plug.

Removing the shelves

1. Open the door completely to prevent damaging the door gasket.
2. Pull the shelf out far enough for the notches on the sides to be
aligned with the plastic stops.
3. Lift up the shelf and remove it. Make sure that the shelves are
correctly positioned when you put them back.
You only need to pull the shelves out forwards by approximately 1/3 to
be able to access the bottles more easily. The shelves have an
emergency stop to prevent them from being pulled out too far when
loaded.

Mounting the handle

IMPORTANT: do not overtighten the screws
Locate the handle (1) over the pins (3) of the door and tighten the
handle by screwing the allen key grub screws (2).
EN
17