Assembly Steps - Viega Multiplex Trio F 6145.4 Manual De Instrucciones

GB
Instructions for use Multiplex Trio F
D
Function of pipe interruptor
The pipe interruptor prevents water

from flowing back into the drinking
water line when the bathtub is
filled.
E

Assembly steps

Install the profile seal and

overflow unit.
Screw the fastening flange
with O-ring into the overflow
unit.
Installation example using

steel bathtub (screw-in valve
22.5 mm).
Tighten screw-in valve with

assembly aid supplied.
Mount overflow pipe and

ensure sufficient insertion
depth.
Tighten fastening polygon

screw slightly.
Mount cover rosette onto the

overflow unit.
Mount connecting elbow
s
onto the drain and tighten
union nut by hand.
After assembly is complete,
 22
perform a leakage test.
F
Cleaning
Unscrew the cover plate per

hand.
Clean the inlet element under

running water.
Replace damaged seals.

To install, follow the same steps in reverse order!
Installation diagram

Tighten the fastening flange.

Installation example using a

plastic bathtub (screw-in valve
30 mm).
Bowden wire length 540 and

725 mm. Mount overflow pipe
and, if necessary, shorten.
Insert inlet element.

Place the cover plate onto the

thread.
Loosen the connecting bend

from the drain and connect
on the water side.
To close the valve cone:
t
Turn the rotatable collar
anticlockwise.
Lift cover.

Loosen internal polygon

screw on the valve cone.
Clean drain casings as

required.
12
Viega connecting set

with concealed pipe
interruptor DN 20 design A2,
DIN 1988-4 and DIN EN 1717
Mount the seal onto the drain

casing.
Insert screw-in valve with seal

into the drain casing. Coat
profile seal on inside with
lubricant.
Bowden wire length 1070

mm. Mount overflow and
extension pipes and, if
necessary, shorten.
Turn the external ring of the

inlet element onto the screw
heads of the screw-in valve.
Screw the cover plate into the

thread manually.
Install the screw connection

piece.
To open the valve cone:

21
Turn the rotatable collar
clockwise.
Loosen internal polygon

screw and remove inlet
element.
Close the valve cone and

hold this position with the
rotatable collar. Remove valve
cone.