Utilitech GU8923-BZ-I Manual Del Usuario página 3

ASSEMBLY INSTRUCTIONS
With power disconnected to your electrical box, remove the old fixture. If your old fixture is attached to
an electrical box having more than two (2) wire leads, it is recommended you use tape and markings
to keep track of which wires were attached to each other.
1. Drill out 2 holes on the base of the fixture (A) that line
up with the electrical box ears (Fig. 1). Thread the supply
leads through the electrical box gasket (FF).
2. Connect the supply leads from the electrical box to the
fixture wire leads using the wire nuts (AA) supplied
in your installation hardware kit as per the
illustration. The black lead from the fixture
goes to the black supply lead and the white
lead from the fixture goes to the white
supply lead (Fig. 2). Secure the wire nuts
properly to prevent the wires from coming
loose. Tape the wire nuts (AA) to the wire
using electrical tape. Carefully push the
excess wires back inside the electrical box.
Hardware Used
AA Wire Nut
3. Secure the fixture (A) base onto to the electrical box
using the machine screws (CC) (Fig. 3). Do not mount this
fixture (A) without the electrical box gasket (FF) in place.
Hardware Used
Machine
BB
Screw
Electrical
EE
Box Gasket
4. Remove the diffuser (B) by unscrewing the 4 diffuser
screws (D) (Fig. 4). Set the screws (D) aside while
installing the bulb (C).
1
2
AA
AA
x 2
3
x 2
EE
x 1
4
B
3
A
AA
AA
BB
A
D
Lowes.com
B
A