Idiomas disponibles
Idiomas disponibles
important safeguards:
Indications For Use:
Aerosol delivery to manage the symptoms of patients
with Asthma, Chronic Lung Disease and Cystic
Fibrosis.
CAUTION:
Federal law restricts this device for sale or use on the
order of a physician.
To reduce risk of electrocution:
- Always unplug unit immediately after use.
- Do not use while bathing.
- Do not place or store the unit where it can fall or be
pulled into a tub or sink.
- Do not place or drop into water or other liquid.
- Do not reach for a product that has fallen into
water. Unplug immediately.
WARNING:
To reduce risk of electrocution, fire or injury:
- Electrical shock hazard. Do not remove the cabinet
or open the cover.
- Disconnect the power cord from the electrical outlet
before cleaning or servicing.
- Do not place this equipment near hot, sparking or
burning objects.
- Do not use oil or grease on or near this device.
- Turn the unit off when it is not in use.
- Keep the cord away from heated or hot surfaces.
- Never drop or insert any object into any opening.
- Never block the air opening of the product or place
it on a soft surface, such as a bed or couch where the
opening may be blocked.
- Avoid the operation in wet or damp locations.
- Unplug the unit before filling the nebulizer.
specifications:
Electrical Requirements:
Power Consumption:
Dimensions:
Weight:
Sound Pressure Level:
Maximum Pressure:
Operating Pressure:
Liter Flow Range:
Particle Size:
NOTE:
Conditions may vary based on altitude,
barometric pressure and temperature.
operating instructions:
1. Place compressor on a stable, sturdy and flat sur-
face such that the unit can be easily reached when
you are seated.
2. Pull out the power cord from the base of the unit
and make sure that the unit is in the "OFF" (O) posi-
tion by pressing on the left side of the switch.
3. Plug the power cord into a 115 VAC/60 Hz wall
outlet.
4. Connect one end of the nebulizer tubing into the
air outlet connector.
5. Add the prescribed medication through the open-
ing on cap using an eyedropper or pre-measured
dose container.
6. Assemble mouthpiece and T-piece and insert into
the top of the nebulizer cap. If an aerosol mask is
used, connect the bottom of the mask to the top of
the nebulizer cap.
7. Connect the tubing to nebulizer air inlet
connector.
115V AC/60HZ
75W
4.3"(H) x 7.7"(W)
x 11.8"(D).
3.7 lbs.
<53dBA
30 PSI
16 PSI
<12 LPM
Less than 5 microns
