Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONNECTING THE STBS700 PUMP TO THE CONTROLLER (CONTINUED)
Option 2 - Use your mobile device or computer to connect directly to the Basement Sentry controller
Instead of using a mobile device and the Z Control
you can also use your mobile device or computer to directly
connect to the controller.
Before you begin:
•
Know what the WiFi router is named (i.e. SSID)
and password. To prevent the most common
troubleshooting issues, double check to be sure you
know exactly how the password is spelled, including
capitalization.
•
Verify that your mobile device has working WiFi
with a strong signal when you are standing next
to the Basement Sentry controller. If the signal is
questionable, the controller may not be able to maintain
a stable connection.
•
Verify your WiFi router is connected to the internet
and that it is broadcasting a visible, secure, 2.4Ghz
network.
•
2.4 Ghz network is required. If you only see 5 Ghz
networks, you may need to log into your dual band
router to choose to broadcast the networks separately.
•
Band steering may need to be temporarily turned off
during setup.
•
The 2.4Ghz network must use WPA or WPA2 security.
WEP and open networks are not acceptable.
1. Plug the controller into AC outlet. The Power LED will illuminate.
The alarm LED and white Z Control will flash once, indicating the
controller is transmitting
* AP Mode is when the controller is broadcasting its "name", or SSID.
The SSID is in a format similar to ZCTL_SSUMP_XXXX where "xxxx"
is the first 4 digits of your controller device ID (See Figure 2). The
Basement Sentry controller SSID will show up in your phone/tablet/
computer's list of available WiFi options, and selecting it will give you
direct connectivity to the controller. This is required in order to give
your controller the password credentials needed to connect to the
WiFi of your choice.
app,
•
Any VPNs or other network controls may need to be
®
temporarily turned off during setup.
•
Create a free account at zcontrolcloud.com.
•
Locate the Basement Sentry Device ID located on the
top of the controller.
NOTE: The above list also helps to troubleshoot
connectivity issues.
If the controller still will not connect after trying the
above suggestions, follow the same steps to connect the
controller to a mobile phone hotspot instead of the home
WiFi router. If the controller successfully connects to the
cloud through the hotspot, then the conflict is probably
related to router settings.
8
© 2020. All rights reserved.
1
Apply AC power to the
controller. The Z Control
®
LED will blink and then
turn off, indicating the
controller is in AP Mode*
and is transmitting an
SSID.
252mm
If the LED is blinking and
not in AP mode, press the
Z Control
button for 12
®
seconds and let go.
The LED will now be off,
indicating the controller
is in AP Mode. A pen or
toothpick or similar is
required to press the Z
Control
button.
®
21mm
POWER
ALARM
SILENCE
Reset:
Press for 3 seconds
B Y
INTELLIGENT
SUMP
CONNECTS TO
MOBILE
DEVICES
Tabla de contenido
