Tips For Saving Energy - SUNFEEL FG1702X Manual De Instrucciones

Recommendations
• If you do not intend to use the appliance for long time (for example during the summer
holidays) unplug and clean the appliance and leave the door open to prevent the
formation of mildew and smells.
• To stop the appliance completely, unplug it from the main socket (for cleaning and when
the doors are left open).
• If a problem persists after you have followed all the instructions above, please consult
the nearest Authorised Service Centre.
• The lifetime of your appliance is stated and declared by the Department of Industry. The
length of time for retaining parts required for the proper operation of the appliance is 10
years.

Tips For Saving Energy

1. Install the appliance in a cool, well ventilated room , but not in direct sunlight and not
near a heat source (radiator, cooker.. etc). Otherwise use an insulating plate.
2. Allow warm food and drinks to cool down outside the appliance.
3. When thawing frozen food, place it in the refrigerator compartment. The low temperature
of the frozen food will help to cool the refrigerator compartment when it is thawing. This
will help to save energy. If the frozen food is put out, it results in a waste of energy.
4. Cover drinks or other liquids when placing them in the appliance Otherwise humidity
increases in the appliance. Therefore, the working time gets longer. Also covering drinks
and other liquids helps to preserve smell and taste.
5. Try to avoid keeping the doors open for long periods or opening the doors too frequently
as warm air will enter the cabinet and cause the compressor to switch on unnecessarily
often.
6. Keep the covers of the different temperature compartments (crisper, chiller ...etc ) closed
7. Door gasket must be clean and pliable. Replace gaskets if worn.
8. Energy consumption of your appliance is declared without
drawers and fully loaded in freezer compartmant.
9. For saving energy, do not use volume between the load limit and
the door, along the load limit line. Load limit line is also used in
energy consumption declaration
EN - 47 -