Be Cool SLAM Instrucciones página 14

SLAM
GB
Assembly instructions
Locate the left and right frame/pivot assemblies. (The Speed Selector Knob and battery
1
compartment are on the right frame pivot assembly)
Pivot the two frame tubes in each assembly apart. Ensure the tubes click into place in the open
position.
(While pressing the frame lock button, fold the frame tube as show arrows.)
Insert each end of the tube into the rear tube of the left and right frame/pivot assemblies. Verify
2
that the spring-loaded button at each corner of the left and right frame has clicked into place
to secure the frame.
Assembly seat pad as shown arrow (Note: round head match round hole, half-round head match
3
half-round hole).
Insert clip into the metal axis as shown arrow, make sure it click into the right slot to secure the
seat frame.
Fold for storage and travel:
4
1.Fold the seat frame up tube A and bottom tube B according to below arrow directions of
picture 1.
2.Fasten the metal button according to picture 2.
3.Press the four buttons according to picture 3 to fold the swing frame, final effect like picture.
If want to adjust the should tape height, please refer to below pictures.
5
Operating instructions:
Place the infant in the seat as below shown. Insert the left and right sets of buckles into the
6
restraint latch.
Adjust the straps in the buckles as needed so that the restraint fits snugly, but not too tightly.
Features
1 -Our SCM control system provides steady motion to calm your baby. Turn the Speed Selector
7
Knob clockwise to any of five positions to start the swing and select the speed. Turn the selector
knob counter-clockwise to the first position to stop the swing.
2 -Use the Swing Timer Select function to turn OFF the swing automatically. Press the button to
sequence to the desired timer setting of 8, 15 or 30 minutes. The three LEDs beside the button
indicate the selected time perio. If you do not select a timer setting (all LEDs are OFF), it will
swinging all the time.
3 -Press the Song/Volume Select Button to start a melody at low volume. Twelve different
melodies will play. Press the button again to increase the volume to higher, press the button a
five time to stop the music. Press the button a sixth time to play another new melody.
4 -The swing control module requires 4 pcs AA size (1.5V) batteries (no included). Or use AC
adapter require:
14 Output: Voltage: 5-6V, Electric current: 350-600mA.