Nacon REVOLUTION X Manual Del Usuario página 12

EN /
I How to use this controller on PC
The Revolution X controller is also a Plug-n-Play device. In other words, the necessary
driver software will be automatically installed when the controller is first connected to
your computer. Here is what to do:
Turn on your computer, wait for it to start, and go to your Windows desktop.
Find an unused USB port on your PC and plug the USB cable of your Revolution X
controller into it.
Windows will detect the new device and, after a few seconds, start installing the
appropriate drivers. The process will be indicated by a small icon in the task bar.
The installation takes more or less time depending on the speed of your system. At
the end of the process, the following message will appear: «You can now use your
Revolution X. »
I Shortcut key configuration
The 4 shortcut keys can be configured in two different ways:
Either using the «Revolution X» Interface with personalisation in advanced mode.
Or
On the controller itself when in 'Standard' mode.
Please note that the procedure below is only valid in standard mode. In Advanced mode,
you will have to configure the shortcut keys using the Revolution X app.
1 Make sure that the Standard profile/custom profile switch (No. 17) is in the
'Standard' position
2 Press and hold the profile button for 3 seconds
The Profile LED indicators are OFF and the ring, around the Right stick, will flash.
3 Press the shortcut button (S1, S2, S3 or S4) that you want to «program» and the
LED corresponding to the button lights up.
4 Tap the button you want to associate with the shortcuts
5 The LED associated with the shortcut flashes 3 times, to confirm the link.
6 If you program the wrong key, simply repeat step 4 and create a link with the button
you want.
7 To link another shortcut to another button, repeat operations 3 to 5
8 To delete a link, once the shortcut has been selected (steps 3), press the same
shortcut again, and the LED corresponding to this shortcut will flash 3 times.
9 Once you have finished your settings, press the profile button for 3 seconds to exit
this mode.
The profile LEDs will go out and the ring, around the Right stick, will be constant.