Extron Electronics PS 1230 Guia De Instalacion

Extron External Power Supply • Installation Guide
®
About the PS 1230 Power Supply
Model Part
Number
PS 1230 70-769-01
8 A peak, 3 A continuous; shared
ZipClip ™ 200 101-001-01
Connector Wiring
Captive Screw
Connector
Tip (+)
Tie
Wrap
3/16"
(5 mm) Max.
Smooth
DC Power Plug
Ridged
Power Supply
Output Cord Captive Screw Connector
Features
AC
Power
Input
DC Power
Outputs
Using the ZipClip 200
Attaching and Removing the Clip and Power Supply
To attach the power supply to the ZipClip 200 mounting clip:
1. Insert the bottom of the power supply down into the clip, starting with
one end.
2. Pivot the other end down and press until the clip snaps into place.
To remove the power supply from the ZipClip:
1. Press the tab on the ZipClip.
2. Pivot the power supply and lift it out
of the ZipClip.
Using Tie Wraps for Cable Strain Relief
1. Attach the power supply to the ZipClip 200 mounting clip as described
previously.
2.
Fasten the power output cord to the ZipClip base.
a. Insert tie wraps (which are also called "zip ties") along the notches
on the side of the power supply and through the ZipClip's tie wrap
anchor points, then around the cord.
b. Connect and pull the tie wraps until they are secure. Do not over
tighten.
Power Output Termination
36 watts, 12 VDC, Captive screw
between all three outputs
—
Smooth
Ridged
Sleeve (-)
Captive Screw Connector
Captive Screw Connector
Notches for
Securing
Tie Wrap
Power
LED
ZipClip
Mounting Slot
(front and rear)
b
a
Tie Wrap
Rack Mounting
Mounting to a Rack Shelf
These power supplies are one eighth rack wide. Up to four power supplies can
be mounted side by side on a rack shelf.
1. Align the threaded holes in the bottom of the power supply with the
holes in an Extron rack shelf and fasten the supply to the shelf with two
—
screws as shown below.
a
b
2. Bolt the rack shelf to the rack.
Mounting to Rack Rails Using a ZipClip
1. Fasten the ZipClip 200 mounting clip to a rack beam using two rack
screws. See the diagram below.
2. Insert the bottom of the power supply down into the clip, starting with
one end.
3. Pivot the other end toward the clip and press until the clip snaps into
place.
Side of Rack
Inside a Rack
Furniture Mounting
NOTE: The ZipClip is shipped with a set of four wood screws.
1.
Attach the ZipClip to the mounting surface using two or more wood
screws as shown below. Make sure the clip is oriented with the
appropriate surface facing the
mounting surface of the
furniture and with the tab
accessible from the
front of the
furniture.
2.
Insert the
power supply
into the ZipClip
as described
previously and
press to snap it
into place.
RSB 123
Rack Shelf
(2) 4-40 x 3/16"
Screws
Rack Mounted
a
b
PS 1230
ZipClip 200
Back of Rack
Under a Desk
1