Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Malfunctions
●
The vehicle cannot be lifted because the lowering
valve does not close:
Loosen the locking nut from the nut (128) by lightly
striking with a plastic hammer, if necessary, and read-
just the play (0.5 - 1.5 mm).
During the adjustment, the spindle should not be
turned.
●
The vehicle cannot be lifted high enough: Check the
oil level as described under maintenance.
Maintenance
Monthly
●
Lubricate the mechanical parts with acid-free oil and
check for damage.
●
l Check the oil level:
Remove the cover plate. Remove the plug screw (15)
on the top of the pump unit. With lowered lifting arm,
the oil level must be 10 mm under the filler opening.
Use only recommended hydraulic oil, not brake
fluid or motor oil.
Quarterly
●
Remove the Seeger circlip rings on the wheels as well
as the casters, pull off the wheels and lubricate the ball
bearings with acid-free grease.
After Several Years of Use
●
Replace the seals as necessary. Use only original
Würth parts.
Contact our customer service when your unit does not
operate flawlessly in spite of having followed the instruc-
tions give above. You will be helped quickly and reliably.
Designation / Description
Cast wheels with rubber covering, 1 set ( wheels)
●
For protecting the workshop floor.
Pneumatic rubber wheels, 1 set (2 wheels)
●
Makes possible easy transport and high manoeuvrability.
●
Wheel must not be dismounted during the lifting process.
Saddle pillow
● Protects the vehicle flooring.
●
Made of oil-resistant rubber material.
Axle traverse
●
Lifting force 1200 kg., min. width 750 mm., max. width 1080 mm.
●
For lifting of front-drive vehicles that have no front traverse.
●
Makes quick changing of wheels possible.
Accessories (not included with the equipment)
Subject to change without notice
Warranty
For this Würth tool, we provide a warranty in accordance
with statutory/country-specific regulations from the date
of purchase (proof of purchase by invoice or delivery
note). Damage that has occurred will be corrected by
replacement or repair.
Damage caused by normal wear, overloading or improp-
er handling is excluded from the warranty.
Claims can be recognised only when the tool is present-
ed undisassembled to a Würth branch office or a Würth
field service employee.
Declaration of Conformity
We declare under our sole responsibility that these prod-
ucts are in conformity with the following standards or
standardisation documents:
89/392/EWG last changed by 98/37/EWG as well as EN
292
05
Adolf Würth GmbH & Co. KG
P. Zürn
for
RHC-2,
RHC-2H
RH-,
RH-6
RHC-2,
RHC-2H
RHC-2,
RHC-2H
R. Bauer
Art.-No.
Pieces
0715 5 165
0715 5 15
1
0715 5 170
0715 5 1
7
Tabla de contenido
