Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GB
Working safely with this machine
is possible only when the operat-
ing and safety information are read
completely and the instructions con-
tained therein are strictly followed.
●
Do not make structural changes to the equip-
ment.
●
The trolley jack is intended only for the lifting of
loads but not for supporting. Working on or un-
der lifted vehicles is allowed only after they have
been secured against tipping over, rolling away
or sliding off and supported with blocks.
●
The trolley jack may be used only on level and
firm surfaces.
Art.-No.
Type
Lifting force
Height min. / max.
Weight
Quick lift
Hydraulic oil:
A
Handle for moving and jacking
B
Knurled screw
C
Foot pedal
D
Support plate
E
Lifting arm
Mounting
Loosen the knurled screw B on the side of the handle
holder somewhat. Insert the handle A and tighten the
knurled screw until it engages in the slot of the handle.
The handle must be capable of being pulled out by ap-
prox. 2 cm and turned.
Operation
Handle functions
Pulled and turned
Not pulled
6
Tool Specifications
0715 5 100
RHC-2
2000 kg
80/500 mm
36 kg
✔
Castrol Hyspin AWS 22 / Shell Tellus HLP - HM 22/ BP HLP 22 / Esso Univis N 22 /
Mobil DTE 22 / Elfona DS 22 / Fina Hydran LZ 22
Legend
=
Lowering
=
Lifting
For your safety
●
The distance to walls, doors and firm structures
must be more than 0.5 m to allow for escaping in
case of danger.
●
The vehicle should not be lifted when damage to
the vehicle could result from fuel, battery acid or
other harmful fluids.
●
Lift the vehicle only at lifting points recommended
by the manufacturer.
●
When malfunctions occur, do not operate the
trolley jack.
●
During lifting, persons are not allowed to remain
in the vehicle.
0715 5 10
RHC-2H
2000 kg
98/735 mm
53 kg
✔
Positioning the Lifting Arm E to Working
Height
●
Operate the foot pedal C to activate quick lifting.
●
Pump with maximum stroke to bring the support plate
●
D quickly to the working height.
Lifting of Loads
●
The optimum force transfer is achieved with short
pumping strokes. Take care that the support plate is
securely seated.l
●
For vehicles that are too heavy, the overload valve
opens and lifting is not possible.
Do not continue to pump when the trolley jack is at
the highest position.
Lowering
●
Pull the handle and turn to the right to open the lower-
ing valve; the lowering speed can be regulated with
the angle of turning.
0715 5 150
RH-4
000 kg
15/560 mm
70 kg
✔
0715 5 160
RH-6
6000 kg
150/570 mm
90 kg
✔
Tabla de contenido
