Morphy Richards 43847 Manual Del Usuario página 5

KT43847MEE Rev1Q7:9225 47507 MEE pump - Jon
USING THE CARTRIDGE
• Little effort - great effect: Preparation of your BRITA
MAXTRA Cartridge is very simple. Please follow the steps
below to enjoy BRITA filtered water.
1 Preparing the cartridge B:
To prepare your BRITA MAXTRA cartridge, please remove
the protective wrapper (note: the cartridge and inside
wrapper may appear moist, this is simply condensation).
Immerse the cartridge in cold water and shake it gently to
remove any air bubbles, the filter is now ready for use.
Note: As is required for some other water filter cartridges,
there is no need to pre-soak the MAXTRA cartridge.
2 Insert in the funnel C:
Place the filter cartridge into the funnel and push
downwards until it fits firmly in the funnel. The cartridge
should stay in place if the funnel is turned upside down.
3 Rinse the cartridge D:
Fill the funnel with cold tap water and allow it to filter
through. Discard the first two fillings or use the water for
your plants. These first two fillings are used to flush the
filter cartridge. Now re-fill the funnel and the kettle is ready
for use.
There is no need to keep the cartridge immersed in water.
• Removing the cartridge with the ring pull E:
To exchange the cartridge after four weeks, simply use the
ring pull handle on the top of the cartridge to remove it
from the funnel, and repeat steps 1-3 above for the
replacement filter.
For information or advice on using BRITA MAXTRA or BRITA
Memo, please call BRITA Customer Care on 0844 742 4800
BRITA MEMO - THE ELECTRONIC CARTRIDGE
EXCHANGE REMINDER
THE BRITA Memo:
For maximum filter performance and for optimum taste, it is
important to change your BRITA cartridge regularly. BRITA
recommends that you replace the cartridge in your
appliance every 4 weeks.
BRITA Memo automatically reminds you when to change
the cartridge:
The unique BRITA Memo measures the recommended time
of use of your cartridge and is easy to use. The BRITA
Memo is located on the kettle lid.
Operation is really simple:
• Start the Memo display F:
To start Memo, please press and hold down the start button
on the lid until all four bars appear in the display and flash
twice. The Memo is now set.
• Functional control F:
The flashing dot in the bottom right corner of the Memo
indicates that the Memo is working.
• Change display G:
Every week, one bar will disappear to show the remaining
cartridge life. After four weeks, all four bars will disappear.
This, and a flashing arrow, indicate that the cartridge should
6/8/10 12:23 Page 5
now be changed. Insert a new cartridge according to the
instructions, and reactivate the Memo as described above.
REPLACING THE BRITA MEMO
BRITA Memo - the electronic cartridge exchange reminder
has a life of approximately 5 years. At the end of the
Memo's life, please remember that it is an electronic device
and to dispose of the Memo according to all applicable
provisions and regulations. To remove the exhausted
Memo, place a screwdriver in the notch next to the Memo
and push it out. Please note that Memo should not be
removed for any other reason than to dispose of it.
More information on the use of BRITA filter cartridges and
the BRITA Memo can be found in the BRITA information
guide supplied with the kettle.
Telephone our replacement parts helpline for your new
BRITA Memo.
SWITCHING ON
You do not need to wait until the water has filtered through
before boiling. Your Morphy Richards filter kettle will boil
and filter at the same time, giving you boiled BRITA filtered
water quickly.
• Boil only as much water as you need, as this saves
electricity.
1 Place the filter kettle on the base unit, ensuring the kettle
locates on to the 360° connector.
• The 360° connector allows the kettle to be located at any
position - ideal for left and right handed users and
convenient positioning on a worktop.
2 Plug in and switch on at the wall socket.
3 Switch the kettle on. The kettle will illuminate internally.
4 When the water boils, the filter kettle will switch off
automatically.
• If you are using the kettle for the first time, discard the
water and repeat once more.
• To re-boil, switch to ON again. If the kettle has just switched
off, wait a minute or so before switching it back on again.
• If you do not put in enough water, or switch on the filter
kettle when it is empty, the safety cut-out will switch off the
power automatically. If this happens, refill and wait a few
minutes for the element to cool, then use as normal.
5 Lift the filter kettle from the base unit by the handle,
ensuring you hold the kettle level.
WARNING: Unless the cartridge holder is fitted correctly, the
filter kettle may not operate correctly and the lid may not
close and lock securely.
WHEN TO CHANGE YOUR
BRITA MAXTRA CARTRIDGE
This depends on water quality and the improvement
required. We recommend that you change your cartridge
after 4 weeks.
The electronic reminder on your Morphy Richards water
g
5