Radio Operations - Clarion CZ101E Manual De Instrucciones Y De Instalación

Audio Setup
Press the [SOUND] button, then press [
] buttons to select USER preset including:
BALANCE -> FADER -> M-B EX -> LPF(low
pass filter) -> S-W VOL (Subwoofer Volume),
rotate the [VOLUME] knob to select a value.

Radio Operations

Select tuner as playing source
Press [SRC / ] button once or more to
enter RADIO mode.
Select one radio band
Press the [BAND] button on the panel to
select one radio band among FM1, FM2,
FM3, MW and LW.
Manual tuning
During manual tuning, the frequency will be
changed in steps.
Press the [ ] / [
panel to tune in a higher / lower station.
Auto tuning
Press and hold the [
on the panel to seek a higher / lower station.
To stop searching, repeat the operation
above or press other buttons having radio
functions.
Note:
When a station is received, searching stops
and the station is played.
Preset scan
Preset scan receives the stations stored
in preset memory in order. This function is
useful when searching for a desired station in
memory.
1. Press the [PS/AS] button.
2. When a desired station is tuned in, press
the [PS/AS] button again to continue
receiving that station.
Note:
• Be careful not to press and hold the
[PS/AS] button for 1 second or longer,
otherwise the auto store function will begin
and the unit starts storing stations.
CM1521194E(CZ101E) manual.indb
,
] buttons on the
] / [ ] buttons
10
BALANCE:LEFT 1-7->CENTER->RIGHT 1-7
FADER:FRONT 1-7->CENTER->REAR 1-7
M-BEX: ON/OFF
LPF: THROUGH/80/120/160
SUBW VOL: (-6)-(+6)
Auto store
Only stations with sufficient signal strength
will be detected and stored in the memory.
Press and hold the [PS/AS] button (1 sec.) to
start automatic station search.
To stop auto store, press other buttons
having radio functions.
Notes:
1. After auto store, the previous stored
stations will be overwritten.
2. The unit has 5 bands, such as FM1,
FM2, FM3, MW, LW. FM3 and MW, LW
can store by AS function. Each bands
can store 6 stations, CZ101E/CZ101ER/
CZ101EG can store 30 stations in total.
Manual store
When one expected radio station has been
detected, press and hold number button 1-6
to store it in the memory.
Recall the stored stations
Press one numeric button among 1 to 6 on
the panel to select the corresponding stored
station.
Local seeking
When LOCAL seeking is on, only those radio
stations with strong radio signal could be
received.
To open or close LOCAL function, press and
hold the [D] button on the front panel, then
press [ ] button repeatedly until LO or
DX displays on the screen, and rotate the
[VOLUME] knob to select Local or Distant
mode.
Note:
The number of radio stations that can be
received will decrease after the local seeking
mode is on.
10
2010-11-3 15:27:37