Uline H-9236 Manual Del Usuario página 6

2. Attach ratchet straps to the stakes loosely.
(See Figure 25)
a. Attach ratchet buckle with loop strap to stakes
by turning the 6" loop at the end of the ratchet
inside out and pulling strap through the loop.
b. Pull slipknot tight over stake.
c. Take loop strap attached to tent and pull it
through reel bars slot of ratchet.
NOTE: Keep ratchet buckle handle facing up
at all times.
Figure 25
a
3. Tighten ratchet straps by holding strap and pulling
all slack through ratchet reel. Pull all slack through
ratchet reel, holding strap with one hand and
cranking ratchet handle with the other.
4. Roll excess ratchet straps
and secure into the ratchet
buckle. (See Figure 26)
PAGE 6 OF 24
ASSEMBLY CONTINUED
b
c
Figure 26
Completed Assembly
with Stakes
IF USING BARRELS (H-9248)
1. Turn the barrel upside down to connect the
mounting plate. (See Figure 27)
Figure 27
6
a. Put a 5/8" washer (1) over the nut and bolt.
b. Place the mounting plate (2) over the washer.
c. Place another 5/8" washer (3) followed by a
3/8" washer (4).
d. Place and tighten the 3/8" nut (5).
e. Flip the barrel right-side up and insert the base
plate (6) through the hole in the plate.
2. Place a pole over the base plate that has been
inserted into the plate. Put bail pin (7) through pole
and base plate to secure. (See Figure 28)
Figure 28
5
7
4
3
2
1
Bail Pin
0721 IH-9236